Fault light on vector battery charger flashing

The Rexton charger 3g-04 is a device used to charge the batteries in Rexton hearing aids. If the charger is flashing red, it could indicate that there is a problem with the charger or the hearing aid battery.
Some possible causes of a flashing red light on the Rexton charger 3g-04 include:

1. The battery is not properly seated in the charger: Make sure that the battery is fully inserted into the charger and is making good contact.
2. The battery is damaged or faulty: If the battery is damaged or has malfunctioned, it may not charge properly.
3. The charger is damaged or faulty: If the charger is damaged or has malfunctioned, it may not charge the battery properly.

I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer. .. rest is up to u.. U can also get free manuals

About what?

You need to replace the battery.

Replace switch. you have already diagnosed problem. What is your question????

According to the manual:
http://servicenet.blackanddecker.com/documents/English/Instruction%20Manual/90556511,VEC026BD.pdf
http://servicenet.blackanddecker.com/documents/English/Instruction%20Manual/90556511,VEC026BD.pdf
Red LED's indicate a low battery charge. I doubt with 2 Red, would start your car.

Did you charge the battery with it still connected? Read your charger instructions as all the ones I used have the battery fully disconnected from the vehicle. I would have the battery load tested first before doing anything else.

Its possible the charger is telling you the battery is too dead for the charger to work. A safety feature to keep from burning up the charger.
I'm not aware of any fuses between the jumping post and the battery. You may have a short in the car that is draining power.

Ladytkk:

The clicking sound is the starter solenoid (a relay) trying to connect the starter to the battery. This is normal when the battery is run down. the first thing to do is to see if you can charge the battery.
If you do not have a charger, see if you can borrow one. BTW, a small charger is a good thing to have, especially if lights or etc are left on and your battery is dead when its time to go to work. You can get a small one at a Walmart like store for a reasonable fee. Connect the red lead of the charger to the red (+) terminal of the battery and the black lead of the charger to the black (-) lead of the battery. Let it charge for at least 5 or 6 hours. Unplug the charger, disconnect it from the battery and try to start the car. It will probably start. At first opportunity, drive the car to one of the major auto parts stores like AutoZone and have them load test the battery. If you need a new battery, most stores will install it right there.

Hope this helps Good luck Loringh Please give me a rating Thks

Sometimes the new battery is not 100% charged. Put it on a charger or jump start the car, the alternator should then charge up the battery.