There are two main components of the cruise control system: the controller and the servo.
The controller integrates all the inputs and tells the servo how far to actuate the throttle plates. Normally, there is no way you can service this item, so if you trace a problem to the controller, you'll have to buy a new one. A bad controller probably will require a service manual for specific diagnostics. You'll also need a scan tool to access any computer trouble codes to boot.
The servo does the work of moving the throttle blades to speed up the vehicle. Conventional systems are actuated by manifold vacuum. Check the linkage from the servo to the throttle to ensure it's properly hooked up and not binding or sticky. Inside the servo is a diaphragm that moves to pull on the linkage. Some older systems, used on cars or trucks that don't have throttle-position sensors, may have a rod that moves in and out of a magnetic coil to tell the controller the throttle position. There are also two electrically operated solenoid valves. One valve admits vacuum to the diaphragm chamber to add more throttle. The other bleeds air back into the chamber to reduce throttle. Normally, they will never be open at the same time, so if one is sticky or leaking, cruise control operation will be erratic at best. Check for leakage with a handheld vacuum pump. A leaky valve may benefit from a quick shot of silicone spray.
Diesels and some late models may use a servo that is completely electrical. These usually are mounted on the fender well or firewall, and are connected to the throttle by a second throttle cable. Other than keeping the cable lubricated and properly adjusted, there's not much to fiddle with. As always, check the shop manual for specifics on your vehicle.
SOURCE: 2003 expedition cruise control inoperative
I had this same Problem and it was a simple vaccuum hose leak connected to the cruise control module. Try replacing this small hose.
SOURCE: 2005 Ford Taurus cruise control stopped working
couple things could had appened first the cruise control module or cru may have went out could be a malfuntion in the with some speed sensors or the vaccum lines have gotten to dry rotted to do the job necessary to maintain the speed
SOURCE: 2004 Ford Freestar cruise control not working
Try pulling up the brake pedal with your foot,Sometimes your brake doesnt come back all the way,and the brake switch keeps the cruise from working.Also,check the fuse.If those answers dont help,It could be the swith itself is bad.Those can be bought at a parts store.
SOURCE: 2003 expedition cruise control inoperative no
I'm having the same issue with mine. Just checked both fuses #5 and #12 under the dash, but both are fine. Can't find Relay #302 for the speed servo. 2003's aren't listed in the recall. Ugh!
SOURCE: cruise control will not turn on. light on dash use
Did you have the recall for the cruise control done ?
recall 05S28. Description: Speed Control Deactivation Switch.
It could be the fuse in the recall harness is blown.
Try the Cruise Control Self test :
----------------------------------
Self-Test Diagnostics
WARNING:
This test is a key on engine off (KOEO) test only that is conducted in park only with emergency brake fully engaged.
1. Enter self-test diagnostics by depressing the speed control OFF switch while turning the ignition key ON, making sure the engine does not start and is not running. The speed control indicator on the instrument panel will flash once to indicate that speed control module entered the diagnostic mode. Five additional flashes at this point indicate a defective speed control servo. Release the OFF switch.
2. Press the remaining switches in this sequence: ON, RESUME, COAST and SET/ACCEL.
If the ON switch is not depressed within five seconds after entering the diagnostics mode, the module times out and the procedure must be started over.
The speed control indicator lamp will flash as each switch is depressed. Press each switch in the sequence immediately after the indicator light goes out for the previous switch.
Note:
There will be a slight delay when the last button is pressed and the lamp flashes.
3. A lamp flash with the last button (SET/ACCEL) indicates that the static test passed. If the lamp does not flash with the last button and there are no additional flashes of the lamp, the switch is defective.
If the lamp does not flash with the last button, and additional flashes occur, follow the chart below for trouble codes:
— 2 flashes - BPP defective, circuit is defective, brake applied, CPP switch or jumper (if equipped).
— 3 flashes - deactivator switch is open or circuit defective.
— 4 flashes - vehicle speed signal is out of range or circuit is defective
4. Immediately (.25 second delay) after the static test, the speed control servo does a dynamic test by automatically actuating the throttle lever from 8 mm (0.315 in) to 12 mm (0.472 in) of travel from the idle position. During the dynamic throttle pull, observe throttle movement to witness any binding or sticking of the speed control cable and correct connection of speed control cable to throttle lever. Make sure the throttle returns to the idle position.
5. Return the ignition switch to the OFF position and proceed to the Symptom Chart.
----------------------------
If the Cruise Control does not enter self test, the fuse in the recall harness ( if done ) is most likely blown and needs to be replaced.
Testimonial: "thank you very much"
On
this case, to troubleshoot this problem, there are solved help links. Click the
link directly and refer the details to solve this problem yourself, with help
of diagrams: ------
-----------
http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-quit-working.html
--------
Horn
and cruise control not working on Plymouth Grand Voyager?
http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-not-working-on.html
------------------
http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-quit-working-on.html
-------------
http://whoisbyme.blogspot.in/2012/07/cruise-control-stops-workingexcessive.html
----------
http://technoanswers.blogspot.in/2012/02/cruise-control-stop-working-on-1994.html
----------
http://schematicsdiagram.blogspot.com/2011/12/cruise-control-not-working.html
--------------
----------
These
will help.
Thanks.
http://technoanswers.blogspot.in/2012/02/ford-ranger-cruise-control-not-working.html
-----------
Horn and Cruise control quit working?
http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-quit-working.html
--------
Horn and cruise control not working on
Plymouth Grand Voyager?
http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-not-working-on.html
------------------
Horn and Cruise control quit working on 2003
Jaguar S-Type?
http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-quit-working-on.html
-------------
Cruise
Control stops working, Excessive cranks to start the engine and RPM goes max
2500
http://whoisbyme.blogspot.in/2012/07/cruise-control-stops-workingexcessive.html
----------
Cruise control stop working on 1994 Ford ranger?
http://technoanswers.blogspot.in/2012/02/cruise-control-stop-working-on-1994.html
----------
Cruise control not working?
http://schematicsdiagram.blogspot.com/2011/12/cruise-control-not-working.html
--------------
1996 Ford Explorer: Cruise Control Wiring
Diagram?
http://schematicsdiagram.blogspot.in/2012/06/1996-ford-explorer-cruise-control.html
----------
These will help.
Thanks.
http://technoanswers.blogspot.in/2012/02/ford-ranger-cruise-control-not-working.html
-----------Horn and Cruise control
quit working?
http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-quit-working.html
--------------
Horn and cruise control not
working on car?
http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-not-working-on.html
------------
Horn and Cruise control
quit working suddenly?
http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-quit-working-on.html
----------
Cruise control stop working ?
http://technoanswers.blogspot.in/2012/02/cruise-control-stop-working-on-1994.html
---------
ford ranger cruise control not working?
http://technoanswers.blogspot.in/2012/02/2005-ford-ranger-cruise-control-not.html
-------------
My Cruise control not working?
http://schematicsdiagram.blogspot.com/2011/12/cruise-control-not-working.html
----------
This troubleshooting help links will help you to confirm the problem.
Thanks.
760 views
Usually answered in minutes!
×