SOURCE: changing rear brakes on 1998 mazda B4000
make sure your brake adjuster is backed all the way off then gently tap all the way around the back to remove
SOURCE: No spark from coil pack
The most common reasons for them going out are not using dielectric
grease properly when installing, and from washing your engine.
I believe this was a huge issue with Volkswagen vehicles
SOURCE: 2003 chev malibu wont start due to lack of spark
That car has 2 crank sensors , did you replace both? One is at the front crank pulley and the other is behind and low on the engine block, above oil pan. Be sure the ICM (ign control module has a good ground, (black wire) it grounds at a bracket where the trans bolts to the engine approx at the 2 o'clock position.
Testimonial: "the check the ground was a good suggestion, i will do that at my first opportunity"
600 views
Usually answered in minutes!
×