20 Most Recent
2005 Mazda MPV Questions & Answers
Rear bumper on mazda mpv
Removal of the rear bumper on an Mazda 2004 to 2006 MPV.
It's afairly simple task: 1) Open the rear hatch or (door) remove the torx screws at the bottom of the weather strip. 2) Remove both tail lights by unscrewing the two phillip screws on each light, once removed the lights pulling toward the side of the van. Let them hang from the wires. You will see a clip (white in color),pry it out from behind the bumper material and go to the next step. 3) Remove three 8mm head screws in each fender well and three plastic clips. Then remove an 8mm screw at the top corner of the bumper against the rear fender. If your car has splash guards remove them as well. 4) Remove the two clips at the bottom of the bumper attached to the under carriage. 5) Pull the bumper toward the back of the vehicle be careful with the tail lights. Remember, they are hanging loose.
And that's it, you have done it.
Ferni
I cant find the relay for my ,05mazda MPV for
There is a 30 amp P.WND fuse in the fuse box-doesn't say which fuse box, but it is position #25 in that fuse box. When the key is turned to on, this fuse should have power. If it has power, then the hot wire from it goes into the power window main switch- the driver's master switch. If the switch has power to it (key on), then suspect the master switch.
How can change blower motor to 2005 mazda mpv
The blower motor is located under the dash on the passenger side of the van, remove any lower dash panels covering the underside of the dash to access the motor. It may be easier to remove the glove box liner for access.
Not finding what you are looking for?