SOURCE: tail lights not working while drive. brake,blinkers work
i have a crown victoria with brake lights no tail lights could you help me?
SOURCE: need wiring diagram for 2008 ford crown victoria
Hello,
You can purchase the wiring diagram for $5.99 from the following site: http://www.wiring-diagram.com/. You can also purchase a wiring diagram book from the following link: http://cgi.ebay.com/ebaymotors/2008-FORD-CROWN-VICTORIA-MARQUIS-WIRING-DIAGRAM-MANUAL_W0QQitemZ120394723100QQcmdZViewItemQQimsxZ20090320?IMSfp=TL090320147007r15080.
Hope this helps,
Chris
SOURCE: '96 ford Crown Victoria....No hazard or brake light no turn sigal
Sounds like the multifunction switch. Try working the hazard switch up and down a few times to see if you get some lights to work. If so then replace the switch.
SOURCE: ford crown victoria
you must replace the multi fuction switch! also known as the turn signal switch! its common on ford crown vic!
SOURCE: my 1998 ford crown victoria
The clicking is coming from the flasher relay, it may be stuck on the power side, replace it.
629 views
Usually answered in minutes!
Does the brake switch have an adjustment on it? I can mash the brake to the floor and the lights will come on. but just press easy and they will not work...
break switch is made easy to be serviced once you take out from the car take a look inside it have 2 group of cathos 2 and 3 the 2 is what connect the juice to the lights the touch when the pedal is depressed but there is a contact raised area between these two cathodes is most likely is worn flat from years of use i would slip out that cathode and apply a little solder on the flattened area but make sure not to over do it or lights will stay on if it does file a bit with a sand paper and safe your self some dought a soldering gun at any 99 cents store is $ 2 to 3 $ and solders is $1 so for under 4 bucks u got ur self a kit that u can even repair window and door switches with until eternety
×