Oil pan how to changed or take it off on a 1995 granam pontiac 3.1 6 sylinder

1. Remove transmission oil pan (be careful oil will splash all over)
2. Remove all bolts slowly, so oil will drain slowly
3. Transmission oil pan gasket is reusable
4. Clean oil pan and let transmission oil drip then reinstall pan and gasket.(At the same time you can change the transmission oil filter.
5. Fill with transmission oil fluid (see specification) 4 liters Dexron4 fluid
6. Start the engine place transmission lever to park or neutral
7. At the same time remove plug (see pictures ) until fluid comes out the transmission plug hole. (replace the plug)



Hope it helps.

need motor 4cy or 6cy

No its easy. Just drain th oil. Remove all nuts around and thats it. Sand the edge realy good before intaling the new gasket and that it. Put it back

Hello vcrash: My name is Roger and I will help you. The low oil sensor will be located in the side of the oil pan. Either on the radiator side of the engine or the transmission side of the oil pan. Most likely the radiator side of the motor. Should you need further help pleae just ask. Please rate the answer. Thank You for using Fix Ya. Roger

the filter is inside the trans oil pan.
have to drop the trans oil pan to get to it.
have to get a new gasket for the pan with the filter.
make sure you have plenty of new fluid to put back in afterwards.

Hi, the oil pan will have a drain hole but you may not see it it is right at the back of the sump so you need to get right under the car to see it but it is their you need to get to it from the back its not in the bottom of the sump but right at the back get under and you should see it.

make sure the car is on stands as its not safe leaving it on jacks it only takes a rubber seal to split for the jack to drop

let me know if you need further assistance ok

plz rate this solution as i have a whole page of unrated posts, thanks

1 Raise and support
2 Remove front diff assembly from chassis
3 Drain oil
4 Remove clutch or torque converter housing lower plate
5 Remove oil pan

OIL PAN BOLTS 6.7 - 8.9 ft.lb
OIL PRESSURE SWITCH 10 ft.lb

sounds like a bad camshaft position sensor

Under the car about dead center between the Front wheels. Should be a 15mm Bolt head. If you can identify the oil drain pan under the car, it's the lowest bolt on the pan.

TOOLS FOR THE JOB:
jack
jack stands
sockets and socket wrench
safety glasses

PROCEDURE:
1. raise your car at all four points, with jack stands
2. drain your oil
3. there will be multiple bolts surrounding your oil pan (about 10 give or take) make sure you are wearing safety glasses, remove these bolts
4. your oil pan should drop, if not provide a little bit of force
5. take your oil pan and remove old gasket
6. clean off area where gasket was removed
7. then do steps 1-3 in reverse