Where is crankshaft located on Mercedes e200, 2007?

• First you will need to make sure that the coil is getting power let us know and then we can go from there.

You are either not getting fuel or the crankshaft position sensor has failed. on some mercedes the fuel pump will not run if the computer does not see rpm. so the easiest and cheapest attempt to repair is replacing the crankshaft position sensor. it is located at the back of the engine near the transmission bell housing.

at rear of engine ,flywheel 5mm allen key or 10mm socket

you can try a serial number search....

The crankshaft position sensor is bolted to the block about a quarter inch away from your crank. Not the crank pulley but the actual crank. This means removing the cover for the timing belt and the timing belt itself along with many other parts. I have a 06 kia optima and I had to replace my crankshaft sensor, believe me you do not want to try unless you are mechanically inclined. If you remove the timing belt cover and look right next to the crank there is a little plastic piece bolted on with 2 bolts. That would be your crank sensor. Don't take timing belt off until you have all components lined up oil pump, crank, cams, etc. Also mark your belt at the marks when they are lined up so when you put it back on you know its right. If you do decide to replace it and you need some advice let me know and I would be glad to help. Hope that info helps you out.

Go to dealership they will give a diagram to locate every single one. I replace them on my daughter car. I believe there were three sensors. I exactly know what you are talking about. I had a hard time locating the back one right above the drive shaft on driver side.

i have mercedes 94 e320 was run ok .but after engine wash
first coil no sparking ,and a the second quit too ,running only whit the third coil ,,i changed all 3 coils but runnig a same,,no sparks on those front 2

Down by the harmonic balancer or behind the harmonic balancer. the harmonic balancer is the lowest pulley that your belt hooks to. there should be a wire connected to it.

Hello, The crankshaft sensor is located at the left rear of the motor, behind the left cylinder head where the transmission bolts up. I believe that it has a 6mm allen head screw holding it down.
I hope this helps.
CYA, Gator241

My car is doing the same. You need to replace the crankshaft position sensor. You can order online for about $60.00. Part is $140.00 at dealer.