SOURCE: need the fuse diagran fo chevy blazer s10 4wd 1991
go to autozone.com, enter your vehicle specs, and follow the prompts for the repair section, then to electrical diagrams..........and its FREE!
SOURCE: Where is the transmission modulator located on the
The modulater valve should be at the rear of the trans on passenger side, near the top and have a vacuum line going into it. Hope this helps.
Testimonial: "thanks - it was easy to locate from your instructions"
SOURCE: 95 s10 blazer 4dr power door locks inop, new
1. Locate the red two wired programming connector located near the central locking control module that is located behind LH Lower instrument panel. Drop the panel and you will see the red programming connector that is not connected to anything.
2. Inside the Red programming connector you will see to pins..
Jump two pins with a section of wire.
3. System should now lock and unlock doors to indicate vehicle has entered programming mode.
4. Press any button on keyless remote once. System should now lock and unlock doors indicating the keyless remote has been programmed.
5. Repeat step 4 to program other remote.
6. Remove jumper wire from programming connector to exit programming mode.
7. Test Remote(s)
1,478 views
Usually answered in minutes!
×