How to install a ignition coil pack for 2007 hyundai accent

How to change spark plugs hyundai accent 01 - 05 - YouTube

? 3:18
https://www.youtube.com/watch?v=tU2vwisJ7v4
Feb 16, 2012 - Uploaded by PNBNC
I filmed this right after changing my old plugs, I figured it was easy enough to film and some people can profit from it. for a ... Coil, you mean wire lol ... When you go to put the spark plug back in, never start it with the ratchet.

How To Replace Change Install Spark Plugs 2001-06 ...

? 3:17
https://www.youtube.com/watch?v=yVV2KcPDFIo
May 14, 2013 - Uploaded by 1A Auto Parts
... spark plugs. This video is applicable to the 2001, 2002, 2... ...spark plugs. This video is applicable to the 2001, 2002, 2003, 2004, 2005, 2006 Hyundai Elantra 2.0L. ... +queentonks A little know-how can go a long way. We're glad ... When do you think is good to replace my spark plugs wires? My spark ...
2001 Hyundai Accent Firing Order: Engine Mechanical ...www.2carpros.com/.../hyundai-accent-2001-hyundai-accent-firing-orderApr 23, 2009 - Engine Mechanical problem 2001 Hyundai Accent 4 cyl Two Wheel Drive Manual 95000 ... Now I'm trying to figure out how they go back on. How do I find out the Engine Firing Order for my car - Hyundai Accent 2001 1.5L?Which is cylinder 1 - 1.6 Accent - Hyundai Forum: Hyundai ...www.hyundaiperformance.com/.../16837-cylinder-1-1-6-accent.htmlJan 13, 2003 - 3 posts - ‎3 authorsFrom what I read though, the coil pack is configured as 1 4 2 3. I'm assuming the first wire on the coil pack goes to cylinder 1. Can anyone ...

Perhaps you might need to check your ignition coil pack. There have some issues with coil packs that when reaching normal operating temperature, cause misfires. Also check your ignition timing

have ur ingintion module checked
and also check ur ignition relay

timing belt bad

Maybe the coil pack module that the coil packs sit on is bad if it's like a GM.

Changing the coil packs alone won't always solve the problem.

hook up a scanner if you have one, check to see if your scanner is registering a crank signal.

Pull the coil pack on cylinder #4 and see if is firing.

If not replace coil pack and all should be ok.

Also check that your spark plug is gapped correctly.

Do not pull the coil pack with your hand when the engine is running as you will get a pretty nasty shock.

Hope this helps you out.

The RPM guage (tachometer) reads the spark impulses from ground terminal of the high voltage sending unit. I've never had to install a tach on an Accent, but for the most part the wire (on other model Hyundai's) is green and connects to the distributor primary or negative (-) side of the ignition coil. And then to the Tach terminal. Do not connect to coil on If yours is an MSD ignition, do NOT connect to the coil!!. Some electronic ignitions have a tach terminal on the ignition box, the green wire may connect there. Hpe this helps....

try unplug the up streem O2 sensor drive the car for a while then check the code if its not p0300 change the O2 sensor