20 Most Recent Hyundai Motor 1995 Accent Questions & Answers

Causes of white smoke when car is cold idling

remove door panel which is attached by screws,peel away plastic liner and look inside door at back of door handle..using needle nose pliers pop off the small steel rods that are for inside door mechanism,then remove the one bolt that attaches the handle to the inside of door and from outside of door remove handle.Replace in reverse order!

Many cars have a manual child lock in the trunk, it might be engaged.

Check if the ignition wires are re-installed with the proper firing order (should be 1-3-4-2) cylinder 1 is closest to the passenger side fender.

Try changing your fuel filter, if that does not fix your issue I would have the catalytic converter changed.

1st you may want make sure that's not an interference engine. if it is then chances are the valves are bend in the head. changing the timing belt probably won't help then. If its not an interference head, then you would need a timing mark diagram which can be found online. be very careful that all marks are aligned. when finshed installing the timing belt, rotate engine by hand twice and re-align marks before putting the rest back together! hyundai should be able to tell u if the engine runs interference or not.

Varies in all cars according to engine. No such length.

Hi and welcome to FixYa,

In a manual 2001 Hyundai Accent, the clutch cable could be adjusted. The adjustment point is on the cable 'pad' where it enters the firewall in the engine compartment.

To adjust, the slack or free play must be decreased. This is done by turning the adjusting nut clockwise. Check back by pressing on the clutch pedal to your preference.

Good luck and thank you for using FixYa.

Click on the following direct, free Link. It has the Timing Belt + Mark Diagrams for your 1995 Hyundai Accent 1.5L SOHC In-Line 4-Cylinder Alpha Engine. Is also has additional - very helpful Instructional and Directional Diagrams.

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

http://www.2carpros.com/car_repair_information/year/1995/make/hyundai/model/accent/1995_hyundai_accent_timing_belt_diagram_marks.htm

This may be from a dry pivot bush or spring squeak. It can also be from a failing clutch master cylinder or a failing clutch cable

what kind of vehicle is it?

misfiring can also be cause by low fuel pressure and injector faults . I would eliminate the low fuel pressure by having a fuel pressure test as it checks the fuel, pump, filters ,pressure relief valve and fuel pressure sensor that controls the fuel pump. Basically if the pressure is not high enough then the injectors do not get to let in enough fuel and so a misfire occurs

Your air/fuel mixture is too rich so it's choking out the engine. Get your mechanic to adjust the carburetor.

i'd try a fuel addative to clear through fuel,cylinder/valves and the cat converter may have a carbon/sludge build up ,cheaper than getting iac and the idle may be the blockage symptom give it a go nothing to loose,must have quite a few miles on it