Subaru Cars & Trucks - Page 7 - Popular Questions, Answers, Tips & Manuals

A motor mount might be broken..

Dealer needs to program it to the keys that you have.

go to a local auto parts store and ask them

Do you get anything at all at the ignition? Lights? Warning messages? A 'Clunk' as you turn the key to start the engine? Please use the comment button below with more information and I'll try to give you more help.

The am antenna is in the radio..it cud b worn or the tuners may hav burnt. Its an old radio. Junkyards hav them cheap n workable cause theyr wreckcars

Make sure battery has a full charge and battery connections all good. Is the vehicle automatic or manual transmission? Is there a security system? I couldn't get the whole diagram in one picture. With starter on vehicle, two voltage circuits, one comes from the battery, hot all the time. The other circuit goes hot with key in the crank position and goes through inhibiter switch for automatic. your security system may be involved and there is a cultch switch for manual transmission. The starter motor grounds through engine block. Any testing at starter motor, make sure transmission is in park or neutral and parking brake is set. Vehicle can't move.

Ask a partstore..its on their data. The delay may b toast..junkyards hav them

MAP sensor is in the air intake plenum.

Does the air not blow out the vents? Is the temp gauge saying the engine coolant is at temp? Does the sir blow but it is not hot? Exactly what stopped working?

Dirty contacts to the battery. Bad grounds, battery to body. Bad ground on Starter Motor. Loose Live terminal on the Starter. Check with a multimeter. The key is voltages and amperage being in the right place. I would also test the new battery for voltage and amps. What happens if you connect jump leads from the battery direct to the starter? Hopefully Jeff Armer will be along, he is our auto electrical specialist. I am just an amateur from the days when fixing scooters, motorcycles and cars was easy.

pictures here https://www.google.com/search?q=1999+subaru+legacy+outback+rear+wheel+ABS+sensor ..

Make sure the brake is depressed and the tranny is in neutral if manual and park if automatic. Wiggle the shifters.

Sorry I can't tell you where or how but it is invariably fitted somewhere in the heater air intake in order to keep it cool as during use on the lower speeds it can become very hot. Most are fitted high in the intake but some are fitted near the motor where the intake narrows to take advantage of the higher velocity air flow.

My first suspicion would be the Security Control Module. It could be going bad. It controls the Interrupt Relay, which allows the starter to crank. If this is reproducable, looking at the computer parameters when it happens may tell you what is input is missing.

Did you check #14 Maxi fuse under hood? Check 1 bulb to make sure it's good, over my career I've seen too many cars come to my shop (Auto Electric) with all the lights burned out. After that I see a relay but you tested it did you swap it with another? That relay looks to be located next to the Maxi fuse. Do this unplug the relay then jumper battery positive into the Green/Yellow if it goes replace relay if not look at the switch check the Green/Yellow and Black/White they should both have battery positive voltage enough to light a regular test light if yes. Replace the switch. I hope this helps. Take care.

Is this to work out which way up it goes into the engine block? If you look closely at the thermostat You will see a large spring on one end. That is the end that goes into the hole in the engine block. when it is in place you should not be able to see that spring.

If you have full battery power then the problem would be a starter motor issue! check wires to starter motor and starter motor itself!

Large vacuum leak, EGR stuck open, weak spark, restricted fuel filter .

I can help you

https://www.youtube.com/watch?v=bqhQ38R017Q Watch this video for help.