20 Most Recent
2007 Toyota Corolla - Page 2 Questions & Answers
What is the code for a bad gas cap? I just
codes p 0440 through to p 0459 all refer to the EVAP system.
code p 0455 refers to EVAP system very large leak which refers to a loose or missing gas cap
manifold leaks are a small leak in the codes and many are miss- read as a vacuum leak can be from the transmission actuator hose missing , and the vent controls leaking
A lot of the EVAP codes refer to the purge valve or the purge valve solenoid
Axio manual
This is Toyota Corolla Axio 2008 model. My A/C isn't working, So I decided to check the Dashboard fuses for A/C. There is no diagram. Can Anyone Help Please?
Park light Intermittent
Workshop manual or youtube , I would try youtube first and put in the same words and go through all the answers ps youtube is my bible for things like this good luck colin
How do I adjust the throttle body
The throttle bodies on most newer cars are not adjustable for its idle speed. If the Check Engine Light is on, go to the nearest auto parts store and get them to pull the error codes from your car's computer. Post the codes back here and we can give you a better answer to your question
Toyota corolla verso 2007 . the central locking
Toyota Corolla Verso - Central locking has just stopped responding
So you don't waste your time, here are some assumptions: -
1. When I press the key fob there is no sound of doors trying to lock/unlock and I know the key fob is fine.
Solution:
In this situation reset the alarm/locking system
Below is the procedure I followed to get the central locking working again: -
Open the passenger door, and look at the side of the dash board. There should be a triangular panel. Pull the panel off to reveal a small set of fuses(see the back of the panel for the fuse map). To power down the central locking you need to remove the Dome Light fuse, this is located top left. Second one down 7.5 amps. (if in doubt remove the top two 7.5 amp fuses I did)
When you remove the fuse(s) you will notice the interior light go out indicating you have powered down the system.
Now leave them out for at least 30 mins so any capacitors can discharge properly. (Be aware while the fuse is removed all central locking is disabled, so the other doors are open. I left the fuse(s) out over night with all the doors open but I don't recommend it, 30 mins should be fine)
After 30 mins replace the fuse(s) close all doors, and then try your key fob, hopefully you should here that satisfying locking sound.
2. When I press the key fob I hear the locking system trying to engage.
This could be a faulty door switch on any door including the boot, or there could be a dent in the inner door panel of any of the doors, usualy the rear doors due to the seat belt not retracting properly.
Solution:
Check all door switches for damage, and check inner panel for dents, just a small dent where the switch connects can be enough to not engage the switch. This will stop the central locking.
Use some kitchen roll wrapped in tape (as a makeshift pad) and tape to the inner door as a temp measure to engage the door switch. At least you can then lock the car.
Corolla rear seat removal
First lift up on the front edge of the seat bottom. There are two hooks that latch it in place. A solid tug on either side will release them.
They are located here:
Next remove the head rests and unbolt the two 14mm nuts on the lower corners of the seat back. From there the seatback will lift straight up.
See illustration here:
If this has been helpful please be sure to rate my answer and thanks for using Fixya!
Not finding what you are looking for?