Top 10 2007 Toyota Corolla Questions & Answers

You may have a buildup of A/C condensate water in the A/C cooler box. Start the car up, and run the A/C; you should start to see water dripping out from under the car onto the street. If not, the A/C condensate tube may be blocked or dislodged from the A/C box. The water then leaks out of the box onto your floor. The drain is on the pass side, under the dash, close to the center console. The pipe goes thru the body. This is a very common issue.

The fuel filter is located in the fuel tank. TO access it, remove the rear seat, and remove the access panel to expose the top of the tank. Remove the top seal, and the whoe assembly comes out as a unit.

First lift up on the front edge of the seat bottom. There are two hooks that latch it in place. A solid tug on either side will release them.
They are located here:


Next remove the head rests and unbolt the two 14mm nuts on the lower corners of the seat back. From there the seatback will lift straight up.
See illustration here:

If this has been helpful please be sure to rate my answer and thanks for using Fixya!

how do you activate the phone or bluetooth system in the axio

Want to get a copy of the toyota axio (x) 2007 model.

ipsum 2001.....is it all the time 4wd all can be shifted.....how to understand audio system function as it is in Japanese

Toyota Corolla Verso - Central locking has just stopped responding


So you don't waste your time, here are some assumptions: -

1. When I press the key fob there is no sound of doors trying to lock/unlock and I know the key fob is fine.


Solution:


In this situation reset the alarm/locking system

Below is the procedure I followed to get the central locking working again: -

Open the passenger door, and look at the side of the dash board. There should be a triangular panel. Pull the panel off to reveal a small set of fuses(see the back of the panel for the fuse map). To power down the central locking you need to remove the Dome Light fuse, this is located top left. Second one down 7.5 amps. (if in doubt remove the top two 7.5 amp fuses I did)

When you remove the fuse(s) you will notice the interior light go out indicating you have powered down the system.

Now leave them out for at least 30 mins so any capacitors can discharge properly. (Be aware while the fuse is removed all central locking is disabled, so the other doors are open. I left the fuse(s) out over night with all the doors open but I don't recommend it, 30 mins should be fine)

After 30 mins replace the fuse(s) close all doors, and then try your key fob, hopefully you should here that satisfying locking sound.


2. When I press the key fob I hear the locking system trying to engage.

This could be a faulty door switch on any door including the boot, or there could be a dent in the inner door panel of any of the doors, usualy the rear doors due to the seat belt not retracting properly.

Solution:

Check all door switches for damage, and check inner panel for dents, just a small dent where the switch connects can be enough to not engage the switch. This will stop the central locking.

Use some kitchen roll wrapped in tape (as a makeshift pad) and tape to the inner door as a temp measure to engage the door switch. At least you can then lock the car.

I couldn't find a good answer anywhere, so I made this video that works for a 2007 Corolla on how to reach behind the back seat and release the left latch.
http://youtu.be/VXKhksv-v5k

I have toyota corolla 2006. Side mirrors are not working anymore. Before I could just them automatically

The back of the stock radio should have a description of what wires are what to help with replacement. Or you can go to your local parts store and buy a chilton manual for your car, they have wiring diagrams in them.