Top 20 1998 Hyundai Elantra - Page 6 Questions & Answers

0helpful
1answer

My car hyundai elantra 1998 stopped while running

It might have something to do with your mass/air sensor located on the intake tube. Try cleaning the mass air sensor with the appropriate cleaner and also try cleaning the throttle body with carb cleaner.
6/8/2010 9:30:24 PM • 1998 Hyundai... • 236 views • 0 helpful votes
1helpful
1answer

1998 Elantra: i need timing marks for 98 elantra 2.0 1.8 l...

the camshaft is the dot on the sprocket there is a small mark behind it on the cover 12 oclock the crank there is a mark on it look to the ten oclock number 1 tdc you will see the mark
5/6/2010 10:01:28 AM • 1998 Hyundai... • 508 views • 1 helpful votes
0helpful
1answer

Accelerator squeeking and internal crunching

Acc. squeek noise due to linkage issue, get it lubicated.

Regarding the clutch, you check the links, clutch plate springs condition. If there is wornout parts get it replaced. Gear shifting will be solved once you fix your clutch problems.
6/4/2010 2:17:13 AM • 1998 Hyundai... • 200 views • 0 helpful votes
0helpful
1answer

I have a 2000 hyundai elantra and the po734 cade

go online - google your po code and you'll find answers. Just browse through all the links.
5/12/2010 10:56:27 AM • 1998 Hyundai... • 298 views • 0 helpful votes
0helpful
1answer

Automatic hyundai lantra 1998 over drive button

my 2000 elantra (2.0) had same prob., got a throttle position sensor (side of throttle body) from junk yard and fixed the prob. But yours could be diff. cuz it's a 98
5/25/2010 8:03:58 PM • 1998 Hyundai... • 183 views • 0 helpful votes
0helpful
1answer

My elantra 98 shutting off while running, what can...

could be the crankshaft position sensor or throttle pos. sensor
5/21/2010 8:54:08 PM • 1998 Hyundai... • 171 views • 0 helpful votes
0helpful
1answer

Can the engine be remved with out taking the

Yes but it is much easier to remove the drive assembly as one unit, there is more room to remove the transmission after the assembly is removes from the vehicle
7/18/2010 12:39:22 PM • 1998 Hyundai... • 40 views • 0 helpful votes
0helpful
3answers

The power window of my hyundai elantra does not

have the electricals checked. mostly the master switch.
4/28/2010 10:06:44 AM • 1998 Hyundai... • 306 views • 0 helpful votes
1helpful
1answer

My e brake isnt holding the car in place

look under car for adjustment in cable to rear-end.
could be time for a brake job.
lining worn down to point it needs to be replaced.
6/25/2010 2:39:45 PM • 1998 Hyundai... • 61 views • 1 helpful votes
1helpful
1answer

Brake lights are always on.

On most of your newer cars like yours the brake light switch is up next to the brake pedal. When the pedal is released, the switch is normally in the off position. It is a threaded switch to allow for adjustments and sometimes that is all that is wrong. I would check that first and if that is not the problem, the switch could be bad. Check it out before replacing it though. Good luck.
6/17/2010 8:13:56 PM • 1998 Hyundai... • 69 views • 1 helpful votes
0helpful
1answer

Before start smell gas and lazy start?

mixture or gas converter problem <replace gas switch or converter>
6/24/2010 2:40:28 AM • 1998 Hyundai... • 58 views • 0 helpful votes
0helpful
1answer

I have a 2000 hyundai elantra and the po734 cade

P0734 means that your transmission is slipping. This being the case, it is not surprising that the gas mileage is poor. You will need to have your transmission checked out professionally. Take it to a trustworthy transmission mechanic or to a dealer. Get a second opinion before you have any work done.
3/21/2010 12:28:43 AM • 1998 Hyundai... • 451 views • 0 helpful votes
0helpful
1answer

My hyundai latra1.6glsi wont start when hot just

Sounds like a problem with your radiator. It gets too hot too fast. Get it checked to make sure that the fluid is pumping thru your engine correctly.
4/25/2010 3:05:57 AM • 1998 Hyundai... • 155 views • 0 helpful votes
0helpful
1answer

Air bag lit on

If the light is continuosly lit that indicates a fault in the SRS system have it checked by a shop you trust or the dealer
4/26/2010 7:38:09 AM • 1998 Hyundai... • 96 views • 0 helpful votes
0helpful
1answer

What is the firing order on the 1.6 engine

To the best of my knowledge the 1998 Hyundai Elantra has only a 1.8L (1796cc) engine. Are you sure on the 1.6L?

For the 1.8L:
Firing Order:
1-3-4-2
Cylinders:
(back of engine)
1-----2-----3-----4
(front of engine)
Ignition Connections:
(back)
o<---1
o<---4
o<---3
o<---2
(front)

As far as the markings on the outside of the engine, I'm not aware of any. However, by placing markings (white paint) on the Crankshaft Pulley (lip) and using the Timing Strobe you can get a relative idea. However this is not totally accurate, as the Camshaft Position is not visible. With a 4-Cylinder Timing symptoms will be very obvious.
Click on the following Link. It has the Timing Marking Diagrams for the inside of the engine.
http://www.2carpros.com/car_repair_information/year/1998/make/hyundai/model/elantra/1998_hyundai_elantra_timing_belt_diagram_marks.htm

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

3/3/2010 3:16:23 PM • 1998 Hyundai... • 408 views • 0 helpful votes
1helpful
1answer

Just bought a 2nd hand '98 model elantra, fuel

FUEL CONSUMPTION CAN BE MANY THINGS LIKE LOW TIRES PRESSURE.LEAD FOOT ON ACCELERATOR .FUEL LEAKS.QUICK STOPS AND GO.DIRTY AIR FILTER.BRAKES DRAGGING.LOW ENGINE COMPRESSION.AND A BAD OXYGEN SENSOR.
3/24/2010 4:03:42 AM • 1998 Hyundai... • 228 views • 1 helpful votes
0helpful
1answer

Everything with this 98 Elantra has been taken

it sounds like the immobillizer is giving bother like the key have u a spare key try it first or key reader faulty
4/16/2010 3:50:35 PM • 1998 Hyundai... • 116 views • 0 helpful votes
0helpful
1answer

Im trying to remove the stock stereo from an older

hmm.....Try Removing The Ash Tray if I'm Not wrong There Should Be Two Screws That Hold The whole panel facing for the radio ect.
3/29/2010 9:30:48 PM • 1998 Hyundai... • 177 views • 0 helpful votes
2helpful
2answers

When should timing belt be replaced on my 2005

hi this should be done every 50,000 miles or 5 years wich ever comes first, and cost is dependent on where you take it, if main dealer 500 to 800 bucks, maybe more maybe less if you take it elsewhere but rough guide only, hope this helps you
3/20/2010 9:24:59 PM • 1998 Hyundai... • 208 views • 2 helpful votes
0helpful
1answer

The inside fuel tank opener does not go back into

bend the holder back into place
5/27/2010 8:39:14 AM • 1998 Hyundai... • 31 views • 0 helpful votes
Not finding what you are looking for?
1998 Hyundai Elantra Logo

421 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Hyundai Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Elantra Hyundai

  • Elantra Hyundai

Most Popular Question

sometimes hyundai wont start elantra

  • Cars & Trucks
Loading...