20 Most Recent 2005 Lexus Ls 430 - Page 6 Questions & Answers

0helpful
1answer

Will not go into gear

My yaris starts but will not go into gear, if I turn off the engine then it goes into gear
1/26/2014 5:58:11 PM • Lexus LS 430... • Answered on Jan 26, 2014
0helpful
1answer

Buzzing sound coming from back end may be differential of 2005 Lexus LS 430

differential sounds when faulty are a deep growl on drive and a high growl during over drive and a harmonic growl when driving normally
1/1/2014 5:01:13 AM • Lexus LS 430... • Answered on Jan 01, 2014
0helpful
1answer

Drivers side mirror loose folds all the way back towards front of car Power operated Lexus Ls 430

I already took care of the problem, Thanks for your concern.... Joe M...........
12/21/2013 11:45:47 AM • Lexus LS 430... • Answered on Dec 21, 2013
0helpful
1answer

Traction control light

bad earth or wheel sensor for abs
11/23/2013 6:48:07 PM • Lexus LS 430... • Answered on Nov 23, 2013
0helpful
1answer

Vsc check

VSC stands for vehicle stability control, or traction control.The computer or the driver has switched the system off. If the computer has disabled the system, you would need to have it checked for trouble codes to proceed.
6/25/2013 5:46:40 PM • Lexus LS 430... • Answered on Jun 25, 2013
0helpful
1answer

My problem is lexus xl 570 good ignition firing ang fuel flow but no start the engin what is the main problem what is the sulotion this problem

well without know what engine you have, and if there are any codes present its hard to say...could be many things...crank sensor, cam sensor, bad timing chain or belt, etc..etc...would need more information from you for a proper diagnosis Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c
12/3/2012 4:26:10 PM • Lexus LS 430... • Answered on Dec 03, 2012
0helpful
2answers

2001 lexus ls430: warning

yaw sensor is out of calibration, most likely from hoisting vehicle in air. sensor needs to be calibrated before light will go out. jump pin 3 and 5 of dlc under driver side dash. connect jumper wire with ignition off, turn ignition on, vsc light should flash, let it flash for awhile (10 sec). turn ignition off and disconnect jumper wire.(do this with vehicle station on ground).
11/14/2012 5:33:20 PM • Lexus LS 430... • Answered on Nov 14, 2012
0helpful
1answer

Blowing blue smoke at start up

Hmm, is this an older car? Blue smoke on start-up is usually a sign of a very minor oil leak going past the rings. I normally do not consider this to be a problem if:
  1. The car has sat for an extended period of time.
  2. It only happens on the initial start up and doesn't do it after sitting for an hour or so.
10/23/2012 2:40:50 PM • Lexus LS 430... • Answered on Oct 23, 2012
0helpful
1answer

2004 Lexus LS 430 how much oil do i need in the transmission

most modern vehicles no longer have dipstics, but there is a fill plug, i do not know where it might be but look for a plug with a allen wrench hole on the tpo or upper side of the trans, with the plug removed add fluid untill you can see it thruogh the hole (if on top) or if it is on the side add untill it just starts to seep out at the bottom edge of the plug hole
9/9/2012 4:01:23 PM • Lexus LS 430... • Answered on Sep 09, 2012
Not finding what you are looking for?
Cars & Trucks Logo

123 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Lexus Experts

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

LS 430 Lexus

  • LS 430 Lexus

Most Popular Question

passenger kick panel located lexus 2005

  • Cars & Trucks
Loading...