20 Most Recent
2006 Honda Odyssey - Page 4 Questions & Answers
Trouble shoot turn signal problems
Check the bulb, Check the fuses, check that you have voltage at the end of the wiring harness just before it goes into the light. If all checks out then you need to look at replacing the signal arm itself on your steering column.
Do you have to have the remote in order program your key
No. programming a new key takes the old key. Turning the ignition on then off and inserting the new key and turning on. If trying to program the old key, this is different. This could be the key, the reciever, or the module has gone bad. Have to computers scanned for codes.
The front fan of the climate control system doesn't work. What fuse do I replace.
It probably isn't blown. The most common failure is the blower motor itself. The brushes wear out. Start the van, turn the fan on and hit the blower motor, located above your feet when sitting in the passenger seat. Just smack it with the palm of your hand. If it comes on you know the blower is worn out. Not too expensive, and easy to replace, 3 screws hold it in. The next most common failure is the resister. Now you need a volt meter, or a test light, and a wiring diagram. But it usually lets the blower work on high only.
I have Honda pilot 2007,
Hi,
OK
this is what needs to be done .You need to disconnect the battery for
and hour then reconnect the battery . Once it's reconnected it should
automatically eject the DVD . If not then it's an internal error with
the DVD player or the DVD is a copy and has a sticker on it causing it
to jam . These are the next steps . If it does not eject it will need to
be sent out for repair .
Let me know,if needed further assistance.
Hope i helped you.
Thanks for using ' Fixya ' and have a nice day!!
Is there a fuse that run the air condition inthe honda odyssey 2006
Hondas all have a fuse and blower relay located in the battery junction block. You can try swapping relays around if the fuse is good. Then verify the blower motor is good by disconnecting it and applying 12v directly to the motor. If this checks good, check for 12v at the blower connector while disconnected, (key on/fan on). Had a CRV in the shop a few days ago with the exact same issue, power to the motor but a weak ground signal. Replaced the blower resistor.
Not finding what you are looking for?