2003 Honda Pilot - Answered Questions & Fixed issues

Pulley Nut is 47 ft lbs. Other information in the link. https://www.google.com/search?q=2003+honda+pilot+power+steering+pump+torque+specs ..

p1750: Mechanical Problem in HydraulicControlSystem of A/T ClutchPressure Control SolenoidValve Assemblies A and B, or Problem in the HydraulicControlSystem

16352

It should cut off after a few minutes . But if not, I would call the dealer and tell him the same story and see what they say

Most likely you have a problem with the shift interlock solenoid located under the shifter. It gets its signal from the brake switch every time its pressed. If your brake lights come on when brake pedal is pressed, then you can assume the brake switch is o.k.

hmm try to check all bolt and pipes

I have same problem but my low beam don't work and drl but my high beam work when flick. is the problem solve?

The code you mentioned is not valid. A possible fix is to replace batteries. Otherwise, you should head down to the dealership or your trusted mechanic, don't try to DIY, this is some complicated stuff if you are not a technician.

It is located under the fuel rail facing you when standing in front of the car. It is between cylinder 4 and 5. need to remove the upper and lower part of the intake manifold

It should be located under the dashboard at the junction with the wall of the center console.

according to a trusty repair program 210 ft/lb

My 2007 Honda Pilot has 2 indicators on...A/T Temp and VTM-4.....Any ideas?

engine mount <?>... just a hunch.

Sounds like the EGR valve's gone. Not a terribly expensive fix.

There is a short on the wire connector at the horn itself.

You need to take this in and have the body control module scanned for proper function.

We had problems with our 2003 radio we found the 5 digits code when we lifted back hatch look towards top and there she is

Little switch on the door is probably the child lock that prevents the door being opened from inside to make it safer for young children. Historically most cars of my experience have rear doors with this facility.

Reset oil service light Honda Pilot. From years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012. How do you reset oil service light Honda Pilot. From years: 2003, 2004, 2005.

1. Turn off the engine. Press and hold the SELECT/RESET button in the instrument panel and turn the ignition switch to run (one position before starting).
2. Hold the button for at least 10 seconds, until the indicator resets.
3. Turn the ignition off and then start the engine to verify the indicator has been reset.

How to reset oil service light Honda Pilot. From years: 2006, 2007, 2008, 2009, 2010, 2011, 2012. Resetting the Engine Oil Life Display if maintenance service is done by someone other than your dealer, reset the maintenance minder as follows:

1. Turn the ignition switch to the ON (II) position.
2. Press the select/reset knob repeatedly until the engine oil life is displayed.
3. Press the select/reset knob for about 10 seconds. The engine oil life and the maintenance item code(s) will blink.
4. Press the select/reset knob for another 5 seconds. The maintenance item code(s) will disappear, and the engine oil life will reset to 100.

All information is taken from the Honda Pilot owners manual.

Karmen, ...What are you calling a "burnt valve"?.. what characteristics are manifesting themselves to make you (or your mechanic) think its a burnt valve?.... Have you ran a compression test on this machine?? ....Remove the head and have a Qualified Professional rework the head..this is not a job for a shade tree .. or your buddy that "thinks he a mechanic".... reply back to me on here.. .. please mark as helpful.. thanks