20 Most Recent 2002 Ford Excursion - Page 6 Questions & Answers

One or more of the jab switches are probably faulty, this creates a open circuit where the lights you mentioned remain on. To deduce which switch might be faulty, open each door and manually press the jab switch until you find the one that does not turn the lights off. Hopefully, this will FixYa!

It is very simple to replace the backup sensor. It is a good idea to put on safety glasses or goggles to keep dirt out of your eyes. The easiest way is to lay down under the back of the vehicle and reach up behind the the rear bumper and disconnect the pigtail electrical plug from the suspected faulty sensor(s). Then simply remove the sensor by pushing from inside of bumper toward the rear of the vehicle. If you are not sure which sensor is bad, and if only one sensor is bad, you should check one sensor at a time. And then with the good sensor in place you could test each sensor to see if the vehicle beeps while reversing towards a harmless object (like a traffic cone). Repeat this procedure with the other three sensors and leave the good sensor in place when the back up sensor system works correctly. Hopefully, this will FixYa!

go to this free Free Ford website to view or download the owners manual for this vehicle.
The proceedure is on page 111.
https://www.fleet.ford.com/maintenance/owners_manuals/default.asp

Hello there:
Just out of curiosity did you change the ignition controle module this sits under the coil packs that is bolted to the engine This tells the plugs when to fire and it can fire on half of it and have the other half not work this is one of the first things that will fail and give this type of a problem also you may want to check the crankshaft sensoer and the camshaft sensor too.
Ok hope this helps alot
Best regards Mike

The first step is to make sure the "balance" on the sound system is centered and not shifted all the way to the right. Contact me on FixYa if I can be of any more assistance. Thank you.

The alternator is located on the driver's side of the engine toward the upper front of the engine compartment. Contact me at FixYa if I can be of any more assistance. Thank you.

The headlight bulb has burned out, replace with correct part number and it should work fine. Contact me at FixYa if you need anymore assistance. Thank you.

The 2002 Excursion does not have an A/C cabin air filter. If I can be of further assistance, please come back to FixYa and I will be glad to help.

It sounds like it is a problem in the front suspension. It could be the upper/lower ball joints, tie-rod end, or a sway-bar link. These are parts that wear out quickly on this heavy vehicle. The sway-bar link is a part that was recalled by Ford Motor Co., have that replaced by your nearest Ford dealership for free. You can check the suspension yourself or go to a car repair facility that offers free estimates, maybe you could get more than one opinion, and go from there.

The first step would be to check the fuse-box for a blown fuse associated with the circuit the horn is on. The fuse box can be accessed on the driver's side under the steering wheel. If this does not help, come back to FixYa, and I will be glad to be of further assistance.

Most likely a door jab switch in a door,most likely the drivers door.

You will have to loosen the striker and slide back, move back in small amounts until door is tight. also make sure its not something inside the door rattling before adjusting the striker.

Is the AIR bag light on too? Sounds like it might be a bad clockspring.

Should be on the passenger side valve cover. It will have a hose running to it and you will be able to pull it out without any tools. One way to check if the valve is still good or not is to shake it and if it still moves freely, then its okay. Since they are fairly inexpensive, I always replace mine anyways. Hope this helps and good luck!

Check the Passenger Compartment Fuse Panel (Page 188 from Owners Manual), is located below and to the left of the steering wheel by the brake pedal. Remove the panel cover to access the fuses. Check Position 26, 10AMP*...



Also here you can download 2002-Ford-Excursion. Hope helps, (remember rated this).

if your brake lights wont work your stop light switch it bad it's under the brake pedal.

its a 25

if you have the right tool, it takes about 30 minutes

See if these Helm diagrams are what you need.

they are pressed in so you will have to get a punch and a hammer to beat them out. The new ones will have to be pressed in or beat in with a hammer. be careful not to get them in crooked.