1990 Dodge Daytona - Answered Questions & Fixed issues
Where does the crank angle sensor go on a 1990
crank angle sensor, Crank position sensor ,reads the position in degrees of the crankshaft. When the sensor reads a set point on the crankshaft it sends a signal to the ECM(CPU) program which then triggers the spark for that positioned cylinder. It also triggers the injector to squirt. Without it the CPU will not know when to set the spark or injector so nothing works.It is constant for all ECM controlled engines regardless. Further the cam shaft position sensor sends a signal to the cpu telling it that the valves are in the correct position for spark,fuel. When the cam belt/chain breaks there is no position regestired so the spark and fuel are shut off
12/28/2014 6:50:50 AM •
1990 Dodge...
•
Answered
on Dec 28, 2014
•
173 views
Cannot find fan relay switch on 1990 dodge daytona
there is two places where relays were placed on these cars. one where everyone knows is under the hood. second less people no is on the drives side up under by the fire wall. you have to take the bottom saftey cover off and than what each one is displayed on the back off the cover.
7/10/2012 5:19:21 AM •
1990 Dodge...
•
Answered
on Jul 10, 2012
•
225 views
Head lights wont stay on
Check your steering column. There is a switch that cancels the turn signals in there. If it's bad, your signals will act funny and this also affects the hazard switch. Banging on the dash is what triggers the signals to work as the vibration goes into the steering column also. You might also want to check the fuses, relay switch, located inside the the left fender next to the steering column. Sometimes, the radio and the turn signals will go funky at the same time. Make sure your radio is grounded.
Hope this helps.
Cheryl
1990 Dodge Daytona 2.5 ltr. Automatic
5/19/2011 2:11:40 PM •
1990 Dodge...
•
Answered
on May 19, 2011
•
243 views
My elictric fuel pump want
Sounds like you may have a bad fuel pump, check your fuel pump relay and fuse first, if you find these 2 items to be operational then you more then likely have a bad pump and that will require removal of the gas tank for further inspection of the pump assembly...
12/10/2010 3:39:29 AM •
1990 Dodge...
•
Answered
on Dec 10, 2010
•
243 views
Got a 90 dodge daytona
they have a computer board in the transmission.
take it to a transmission shop and let them check it .
might need to be rebuilt.
7/27/2010 5:11:12 PM •
1990 Dodge...
•
Answered
on Jul 27, 2010
•
240 views
Need to locate the fuel pump relay on my 1990
don't go too far yet, have you checked if you have voltage to the fuel pump?? any relay will be close to the fuse box, disconnect the harness to the pumptas close to the tank as you can and check there
5/7/2010 11:04:45 PM •
1990 Dodge...
•
Answered
on May 07, 2010
•
307 views
The wiring in my 3.0L v6 1990 dodge daytona is
Sound like you crossed the wire and either grounded a positive wire or you have a bad ground to you engine block. Check all conections and make sure they are clean and not coroded. Clean with baking soda and water. Make sure the wires are attached at the proper points before proceeding to start the car again.
2/16/2010 3:58:32 AM •
1990 Dodge...
•
Answered
on Feb 16, 2010
•
127 views
Not finding what you are looking for?