20 Most Recent 2003 Pontiac Grand Am - Page 6 Questions & Answers

A blend door activator is broken. You may be able to open the door from under the dash or behind the glove compartment.

try removing the hazard flasher, if the clicking persists try the drl relay, unless you can isolate what is ticking the only way to find it is to disable one circuit at a time

Dennis has the right answer. The bulbs come out with a flat screw driver/ small one. Dealer or junk yard item though.

Could be a bad coil pack, when they are cold they make connection but as they beat up the crack in a bad coil will separate causing the engine to stop running when warm. I have had this issue on several gm vehicles.

There was a recall on these a number of years back, check and see if they will still replace it at any gm dealer.

It is most likely the Strut tower mount. which I had to replace on my 99 gt. I also had the mount on my power steering go which made a similar sound.

There is a clip to release on the wiper blade itself

Do not believe this are replaceable. Light bulbs are soldered into the circuitry of the heater controls.

The part where you insert the key needs to be replaced. Disabling the air bag and obtaining the special tools to get the steering wheel off can get expensive for a one time use. Go to the dealer to get it fixed. It may be covered on a recall too, so check that too.

Here's a link to 5 recalls on the 2003 Grand Am. The third one down has to do with certain replacement models of Delphi fuel regulators, which can leak and cause fire in the engine compartment. (But it sounds like it doesn't apply to original equipment regulators that were not replaced). http://www-odi.nhtsa.dot.gov/owners/SearchResults;jsessionid=8nlWJRrTk1M3hGWvLTG1r6slhL3vygZL2z2Lw8ryHtnG4Gh0npsr!-311432997 Here's another link, where you can look up recalls on your exact vehicle by entering your VIN number. Recalls Defects

here

many possibilities. most common is the security(theft) light blinking? if so place key in the run position for 20-30min than try starting.if that works replace the ignition switch and key.cheers.

Could be starter,it turn over or not.bad connection,check battery.

have you checked for spark you don`t say. also if you order a manual for your specific car and engine size you won`t have a problem.

the mark should be molded onto the plastic cover ,there will be one for tdc,and the required timing degree,some cars have a plastic bracket,with marks molded into it,you never said what size engine so i couldn't answer your question completely because the degree settings vary with engine size.and type.theres no adjustment on this year anyway this i know.

Most likely a bad vacuum brake booster. They leak internally and cause a lean fuel mixture when you apply the brakes.

What engine? have you checked the fuel pressure regulator to see if it is leaking? I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa