2007 Dodge Charger Daytona R/T Sedan - Answered Questions & Fixed issues
Car wont stay started have changed my crankshift position sensor
How do you know it needed a crank sensor ? Does it have spark , did you pull a coil if it has coil on plug ignition or plug wire an see if it has spark ? If there is spark you do not need a crank sensor ! Try spraying carburetor cleaner in the intake an see if it fires , if it does you have a fuel delivery problem ! An when you change a crank sensor you need to have a crank relearn done with a scan tool. not a code reader !
3/22/2015 7:31:40 PM •
2007 Dodge...
•
Answered
on Mar 22, 2015
•
116 views
Charger 2007 i changed FCM then dashboard lights flashed
This could be something as simple as a ground not making good enough connection. The fact that it worked for an hour makes me think it could be a simple fix. First check all fuses to make sure they are good. Then, scan the system for any fault codes at all. If you can provide some codes or a little more information I would like to assist you further. Fianlly, focus on the fuse box under the hood, its called a TIPM (totally integrated power module) this is like the brain of the vehicle so it would be a very good idea to start your troubleshooting there. Good luck!
Regards,
-Tim
1/6/2015 3:45:17 PM •
2007 Dodge...
•
Answered
on Jan 06, 2015
•
209 views
Power loss and knocking in engine
ur engine must be reboured & by replacing piston rings the leakage
of oil is prevented
then u will get the original power $ good acceleration
11/7/2013 5:11:07 PM •
2007 Dodge...
•
Answered
on Nov 07, 2013
•
397 views
Incorrect gear ratio?
Contact your local dealer, you have a slipping transmission most likely.
4/18/2013 5:11:05 PM •
2007 Dodge...
•
Answered
on Apr 18, 2013
•
248 views
Battery replacement costs
That sounds quite high. Have you tried stores such as Batteries Plus, Auto Zone, etc.? They will most likely have what you need and most install them for you.
8/23/2012 11:34:32 PM •
2007 Dodge...
•
Answered
on Aug 23, 2012
•
79 views
How do I replace thermostat on a 2007dodge charger?
First drain radiator about half way then follow the top radiator hose back to the engine and at the end of the hose should be your thermostat housing.Take the 2 bolts out and pry the housing up the thermostat will be underneath.Make sure the new thermostat is put back just like the old one.Look at which end is up.
1/11/2012 5:44:37 PM •
2007 Dodge...
•
Answered
on Jan 11, 2012
•
972 views
I have a 2007 Dodge Charger RT. Suddenly my
if you have the No-Nav system and/or the antenna is in the rear glass, then yes it's will effect signal strength. Some ppl with dark tinted glass have complained.
8/13/2011 7:58:56 AM •
2007 Dodge...
•
Answered
on Aug 13, 2011
•
1,334 views
2007 dodge charger 3.5 v6 is overheating and has
i have a awd 300 same problem 3 yrs in a row... 1st 2 times the replaced the themostat and flushed radiator... 3rd time the had to replace the oil cooler and completely flush the whole system again. tech at dealer told me it is a bad design flaw.... chrylser does not seem to be in a big rush to fix it.... trading for anything other than chrylser product ASAP !!
12/3/2010 2:51:43 PM •
2007 Dodge...
•
Answered
on Dec 03, 2010
•
695 views
Engine skipping
well i had a 98 dodge neon that seems like it did the same and it said engine misfire and all i did was due a tune up change spark plugs and wires.
5/21/2009 3:00:33 AM •
2007 Dodge...
•
Answered
on May 21, 2009
•
995 views
Not finding what you are looking for?