2009 BMW 535i - Page 3 - Answered Questions & Fixed issues


This for 2.0L engine. right or wrong, It's all I have. good luck
oil pressure sending unit-5ljxuf4zpkgfllzhaznbr1gh-5-0.jpg

BMW Cars &... | Answered on Aug 08, 2019 | 33 views


I got this free Pdf manual from reliable-store for free and I don't think Ive visited a mechanic or fixya for help for more than 3-4 times out of the 20 times I fixed the chipper in these 4 years

BMW Cars &... | Answered on Aug 03, 2019 | 23 views


Some fixya use r told me this website reliable-store it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try

BMW Cars &... | Answered on Jul 30, 2019 | 24 views


You will get all the information on BMW Cars
from here https://big-manuals.com/collections/bmw-cars-repair-service-manuals. Download your PDF copy today or email us to biggmanual@gmail.com for ordering a book, CD/ DVD.

BMW Cars &... | Answered on Jul 25, 2019 | 48 views


I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can also get free manuals

BMW Cars &... | Answered on Jul 23, 2019 | 18 views


In the Engine Block

BMW Cars &... | Answered on Jul 13, 2019 | 27 views


Remove the battery and take it to an auto parts store for a (free) test. A failing battery can have enough power to activate some circuits (warning lights, sensors, etc.) but not enough to crank the engine (even if it's showing 12 volts or more).

BMW Cars &... | Answered on Jul 06, 2019 | 16 views


Assume you've checked the voltage on the battery? Do the headlights work? There can be enough juice left to activate the dash lights or (sometimes) activate the starter relay (clicking noise), but not enough to start the car. Voltage should be at least 12 v.
If good, try removing the battery cables and cleaning off any corrosion w/ fine sandpaper or steel wool. Try again -- if no luck, then check the main ground connections (engine and body) of the black battery cable.
If still no start, might be the starter relay. Figure out where it's located (check owners manual or online), then see if there's another non-essential relay (or spare) that you can swap in for testing purposes.
Finally, if all else fails, remove the battery and take it to an auto parts place for (free) testing. After charging, they'll test it under load. Sometimes a battery's voltage will be OK, but when a load is applied, the voltage drops too low.

BMW Cars &... | Answered on Jul 06, 2019 | 19 views


need to reset

BMW Cars &... | Answered on Jul 05, 2019 | 24 views


U need a bew one if its rattles when starting..do it bfore u ruin engine. Hav guides tensioners done too along w a new waterpump

BMW Cars &... | Answered on Jul 05, 2019 | 88 views


Both facing upward, with the flat parallel to the engine deck. Then the #1 cylinder lobes should both be facing upward (relative to the engine deck- remember the engine sits tilted at an angle in the engine bay), and slightly pointing inward toward each other.

BMW Cars &... | Answered on Jul 01, 2019 | 21 views


The passenger mirror system is designed to point down when reversing- if the mirror adjust switch is to the driver side. If you don't wish to have it do this, keep the adjust selector switch pointed to the passenger side. If that switch is malfunctioning it could also explain why you cannot adjust the driver's mirror.

BMW Cars &... | Answered on Jul 01, 2019 | 26 views


I drive s similar year 325i with the same engine, average approximately 28 miles per gallon of spirited driving. You should get between 26 and 30 depending on how aggressively or conservatively you drive. Use mid or premium grade gas and you'll get slightly better fuel mileage.

BMW Cars &... | Answered on Jul 01, 2019 | 35 views


Always check the ground connection/wire. That usually all it ever is.

BMW Cars &... | Answered on Jun 24, 2019 | 20 views


Check for power and ground to the bulb connection . Look inside both male and female connectors for corrosion, bent terminal pins or backed out pins .

BMW Cars &... | Answered on Jun 26, 2019 | 43 views


check all fluid levels and their condition in limp mode have vehicle scanned for trouble code

BMW Cars &... | Answered on Jun 24, 2019 | 20 views


The secret is hidden at the back cover of the number plate light - Remove the cover of the number plate lights, put 12V on wires and it should open. We have to disassemble the cover of the number plate, take out the lamp, connect to an external battery, click the Open button on the key fob and we get the miracle right in front of our eyes! It's confirmed.

BMW Cars &... | Answered on Jun 23, 2019 | 58 views

Not finding what you are looking for?
2009 BMW 535i Logo

3 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2008 BMW 535 i
2008 BMW 535 i

-3 Questions

2010 BMW 535i
2010 BMW 535i

-3 Questions

1988 BMW 535i
1988 BMW 535i

-4 Questions

Top BMW Experts

stephen Kiarie
stephen Kiarie

Level 1 Expert

32 Answers

Roy Cunningham

Level 1 Expert

35 Answers

vince

Level 3 Expert

1234 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...