20 Most Recent 2013 Buick Verano Questions & Answers

get up speed but dont over power it dont make it spin

2013 Buick... | Answered on Mar 04, 2015

Remove the two screws retaining the sail panel/speaker grille assembly and remove the panel/grille from the door. Remove the three screws retaining the front door trim panel to the front door.

Buick Verano... | Answered on Feb 16, 2016


New no. for crdit card


Plz help me.

New no. for crdit card (mail ID)

My crdit card in lock for six month complit.

card no.4181 5702 0303 5915.

Dt.Valid from 02/09 ,Dt.vlid thru 01/19.

My name.satish sakharam choudhari.
Mob.no.9270377030 sat.choudhari@gmail.com

Best Regards

Satish Choudhary

on Oct 07, 2010 | Buick Verano Cars & Trucks

it is a safety requirement that the cap has to pushed down to allow it to turn
have you tried that process

Buick Cars &... | Answered on Nov 06, 2019

First why are you adding it are you overheating? Just a question here for a regular coolant change after you add it you must run the engine to circulate it but when drain it if you didn't drain the engine also there's still fluid in there and that's why only a little bit did you remove the coolant bottle cap when draining it ? Also you obviously had the car jacked up so this raises the engine on an angle keeping a lot of fluid in and you need to remove the lower hose for it to come out on level ground

Buick Cars &... | Answered on Nov 05, 2019

Engine misfire can be caused by a lot of things, such as lack of spark, low compression, poor fuel quality, metering, unmetered air entering the engine, etc., which leads to lack of combustion. When this happens, the computer triggers the Check Engine light and shows a code such as P0305.

I would start with the plugs and wires, then the coil. If it persists, further expert analysis would seem to be needed.

Buick Cars &... | Answered on Nov 03, 2019

The ECM in those years had removable Proms and did not need flashing as new ones do . Some relearning is performed as the vehicle is driven . What quirks are you having ?

Buick Cars &... | Answered on Oct 31, 2019

Any DTC'S - diagnostic trouble codes stored in any module ? PCM/ECM , BCM , TCM etc..... That would be the first diagnostic step - hook up a factory or some other type of professional scan tool . We don't guess , we test . Then we read service information on how it works . Or suppose to work . Backup Lamps The CHMSL/BKUP fuse in the instrument panel (I/P) fuse block supplies battery positive voltage to the body control module (BCM). When the driver places the gear selector in to the REVERSE position, the powertrain control module (PCM) sends a class 2 message to the BCM. The BCM then applies battery positive voltage to the backup lamp supply voltage circuit. The left backup lamp is grounded at G301 and the right backup lamp is grounded at G302.
DTC B2545 Backup Lamps Circuit
DTC B2545 is set either when the backup lamps supply voltage circuit is shorted to ground or opened, or if the CHMSL/Bkup fused voltage supply circuit to the BCM is shorted to ground or opened.
If no DTC'S are set ,then go to diagnostic flow chart . Backup Lamps Always On
Schematic Reference: Exterior Lights Schematics
Connector End View Reference: Master Electrical Component List in Wiring Systems
Did you perform the Diagnostic System Check - Vehicle?
Go to Step 2
Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
Place the gear selector to the PARK position.
Are the backup lamps OFF?
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
Go to Step 3
Disconnect the body control module (BCM) connector C2.
Are the backup lamps illuminated?
Go to Step 4
Go to Step 5
Repair a short to battery positive voltage in the backup lamps supply voltage circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you complete the repair?
Go to Step 6
Replace the BCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Go to Step 6
Operate the system in order to verify the repair.
Did you correct the condition?
System OK
Go to Step 3

Buick Cars &... | Answered on Oct 31, 2019

You can remove the back seat, and it should give you enough room to pull the inner door panel off..

Buick Cars &... | Answered on Oct 28, 2019

On the steering wheel

Buick Cars &... | Answered on Oct 28, 2019

Check wiring. The main battery cable at starter as well as the line going to the battery fuse box at starter is likely lose or has defective terminal end.

Buick Cars &... | Answered on Oct 27, 2019

Not finding what you are looking for?
2013 Buick Verano Logo

5 questions posted

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Verano Buick

  • Verano Buick

Most Popular Question

drive up hill in snow traction control

  • Cars & Trucks