Dodge Ram B250 - Recent Questions, Troubleshooting & Support

https://www.google.com/search?q=1989+Dodge+Ram+B250%2C+fusebox+wiring ..

take of the little panel under wind sheild youll see the mechanism remove bolts on wiper areas after you remove the wipers then get 2 packets of conectors from auto shop few bucks for 2 you need 4 lubricate and use a large socket and a mallet to seat the plastic conectors then replace the mechanism !! sounds difficult but its pretty easy if it doesn't work you need to recheck which way the bars are I messed it up once and it didnt work replaced the plastic conectors other way round reinstalled and done it worked

Check your fuel pressure, and EGR valve and sensor. Doesnt sound like a spark problem since it starts right back up. You can go to Kragen and check and get a fuel pressure test kit.

Sounds like the fuel pump is going out. Its inside the tank. But first see if the fuel pump is clooged. take it off and see if its plugged. Check fuel pressure if you can. should be 45-55 psi

On this website you find fuse box diagram and description for Dodge 1500 (2006) Dodge 1500 2006 fuse box diagram

Plugs are located on the side not on front, tray and check water pump seal.

If you talking about obd connection on driver's side near hood release

Most accessory drive belts have an idler pulley that tensions the belt. The idler pulley either has s 1/2 inch square drive hole or some other way to apply force to counteract the spring. Identify the idler pulley and push it in the direction to loosen the belt, then remove it.

No relay.is there continuity fro msender to inst.panel conector

The ignition module is built in to the computer (PCM)