Kymco ATVs - Page 3 - Recent Questions, Troubleshooting & Support

You can run sae 10A-40 in it and up to sae 20w-50 as well. It varies in prices. Best place would be somewhere like a Walmart. Usually around $4-$10 depending on what ya get. The transmission oil for it is sae #90

Bad pulsar unit Bad CDI unit Bad gearbox electrical unit Bad coil Bad HT lead or caps Bad spark plug Bad earth wires Bad ignition key switch Contaminated fuel Dirty carburetor

Cylinoid could be bad which is quick fix. If not check magneto possibly need a new one or sometimes if it has rust on it you can take some sand paper to it...

adjust valves? check for air leaks, good air filter.

clicks, wont crank ??? check ground first, then suspect a bad starter as long as the solenoid and battery are good... a 12v test light will help here

If its carborated check the float level.

belt slipping needs new one as it wears jus the edges

Geez dont keep spending money if your not sure. It sounds like your starter is not throwing in far enough to engage with the ring gear. Please do your hip pocket a favor and get an auto technician to check it before buying a new starter as well. You can also remove the starter and check the gear to make sure its not worn as some are plastic.

does it idle up and down at will,,,, and gets worse when hot? (if yes - the valves are too tight!!) maybe a little hard to start...?? The carb may need a professional cleaning!

Is it a battery powered vehicle? Email me at [email protected]

broken throwout clutch springs?