20 Most Recent Kymco 2011 Mongoose 90 Questions & Answers


join the wires on the back of the ignition switch. Power wire to one of the others until the ignition light comes on. Better to buy a new key though.



KYMCO Mongoose 90 Specifications KYMCO USA

Kymco 2011... | Answered on Jan 29, 2017


Cylinoid could be bad which is quick fix. If not check magneto possibly need a new one or sometimes if it has rust on it you can take some sand paper to it...

Kymco 2011... | Answered on May 13, 2015


make sure filter is clean not gunked up..try draining carb if there is a plug if not.Then try to clean the carb the jets could be clogged not hard at all to take apart.Good luck

Kymco 2011... | Answered on Mar 15, 2013


do you have internet where you live? Try this
"2002 Polaris trailblazer users manual"

ATVs | Answered 2 days ago


Yea, what you said == just google it.

ATVs | Answered 2 days ago


Usually, there is a hole plug near the bottom of the casing. BUT first drive it around a lot cause gear oil is heavy and it won't come out very fast if it is cold.

ATVs | Answered 2 days ago


power to efi module? no, find where it stopped and reconnect.
yes, power out of efi module? no, replace efi module.
yes, open between efi and pump.

ATVs | Answered 2 days ago


search engine are more efficient. If this isn't to your liking
https://taotao.zendesk.com/hc/en-us/articles/204167645-General-Torque-Spec-Settings-
try searching "clutch nut torque spec"

ATVs | Answered 2 days ago


are you into troubleshooting? Probably not, but one must have fuel, ignition, and air to make things burn or run an ICE.
What don't you have?
Is there an ignition source? Did you pull the spark plug and verify it will spark?
Is there fuel? No, not in the tank, it must be getting to the engine.
Is the spark plug wet? If it isn't wet with fuel, you are not getting fuel.
Is there air? No, not what you are breathing, but getting to the carburetor. Did you check the air cleaner?

ATVs | Answered 2 days ago


It acts like you have burnt spots on the starter shaft that touches the brushes ( voltage) to start. When you rock the vehicle in gear the starter shaft moves and it is placed in a position where the brushes can make a clean contact. Then when you turn the key, the starter will engage and the vehicle will start. My recommendation would be to change out the starter.

ATVs | Answered 3 days ago


check wire harness for short

ATVs | Answered on Oct 10, 2019


It sounds as though your ignition switch is not hooked up correctly. Follow the harness from the ignition switch to the bullet connectors under the front body plastic. Make sure the colors all match up.

ATVs | Answered on Oct 08, 2019

Not finding what you are looking for?
Kymco 2011 Mongoose 90 Logo

3 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Kymco ATVs Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

 Scott Tx
Scott Tx

Level 2 Expert

604 Answers

john h

Level 3 Expert

22408 Answers

Are you a Kymco ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Mongoose 90 R Kymco

  • Mongoose 90 R Kymco

Most Popular Question

hot wire mongoose 90

  • ATVs
Loading...