perrynbecky1 posted an answer for this Ford Cars & Trucks:
"First make sure the battery is disconnected to avoid blowing out your air bags. Next..."
perrynbecky1 posted an answer for this Ford Cars & Trucks:
"There are several reasons for engine knock which usually aren't good: 1 if it's a slight..."
perrynbecky1 posted an answer for this Ford Cars & Trucks:
"You could have a steel belt shifting, a wheel hub bearing problem, or a severely cupped..."
perrynbecky1 posted an answer for this Ford Cars & Trucks:
"Typically you will hear clicking in the turns, such as when you pull in or out of a..."
perrynbecky1 posted an answer for this 2003 Ford Explorer Sport:
"You need to check the relays, but the connection pigtail might have been disconnected..."
perrynbecky1 posted an answer for this Ford Cars & Trucks:
"No forward gears or reverse, I would check the fluid level first. Otherwise your torque..."
perrynbecky1 posted an answer for this Ford Cars & Trucks:
"The most likely culprit is the circuit board in the tail light assembly. Doorman makes a..."
perrynbecky1 posted an answer for this 2004 Ford Excursion:
"I have been told there are 5 different possible codes, but I can't imagine there are only..."
perrynbecky1 posted an answer for this 2001 Ford Taurus:
"It will be to the left of our brake pedal. You might have to remove the lower access..."
perrynbecky1 posted an answer for this Ford Cars & Trucks:
"Do you live in a high humidity climate? It sounds like that is the case. There would be no..."
perrynbecky1 posted an answer for this 1984 Ford Ranger:
"The firing order is 1-3-4-2. The firing order goes clockwise, and number 1 starts in the..."
perrynbecky1 posted an answer for this 2003 Ford Explorer Sport Trac:
"First you want to remove the brake caliper assembly, rotor, and then the axle hub. Then..."
perrynbecky1 posted an answer for this Ford Cars & Trucks:
"Fuel filter or catalytic converters could be plugged."
perrynbecky1 posted an answer for this Ford Cars & Trucks:
"First bring the engine up to top dead center and compression stroke confirmed on No 1..."
perrynbecky1 posted an answer for this Ford Cars & Trucks:
"Google has the fuse box diagram readily available."
perrynbecky1 posted an answer for this 1995 Ford Escort:
"You could also have some wiring problems or an ignition module that has went south too...."
perrynbecky1 posted an answer for this Ford Cars & Trucks:
"Have you checked the gear drive on the bottom of the distributor? I have seen the rolled..."
perrynbecky1 posted an answer for this 1998 Ford Taurus:
"Have you tried to Google it? Here is what I found on this page I looked..."
perrynbecky1 posted an answer for this Mazda Cars & Trucks:
"This is going to sound like a silly question but are you sure that your polarities on your..."
perrynbecky1 posted an answer for this 1999 Ford Contour:
"No, if you have no overdrive, it's likely to be the solenoid, or an internal problem with..."
perrynbecky1 posted an answer for this Oldsmobile Cars & Trucks:
"If that valve on the heater hose is not opening and closing, check the hose going to it..."
perrynbecky1 posted an answer for this 2000 Plymouth Grand Voyager:
"Has both problems occurred at the same time? You could have 2 problems, one being the..."
perrynbecky1 posted an answer for this 1998 Holden VT Commodore:
"I am not too familiar with Australian vehicles, except the rebadged Holden Monero that was..."
perrynbecky1 posted an answer for this Acura Cars & Trucks:
"Get some special crimping pliers to minimize fluid spill, unbolt the bracket holding..."
perrynbecky1 posted an answer for this Ford Cars & Trucks:
"From the looks of my research, it sounds like you have an EGR flow insufficient..."
perrynbecky1 posted an answer for this Ford Cars & Trucks:
"Check to make sure there aren't any vacuum leaks. Did this problem start after doing the..."
perrynbecky1 posted an answer for this Dodge Cars & Trucks:
"Driver's side to the right of the steering column. It's held in with 2 bolts.."
perrynbecky1 posted an answer for this Cars & Trucks:
"Sounds like the ignition module is going bad. Some will "overheat" and stop working. That..."
perrynbecky1 posted an answer for this Cars & Trucks:
"It sounds like you might have a break in the wiring going to the tail lights. Does your..."
perrynbecky1 posted an answer for this 2007 Nissan Altima 2.5:
"There's a lot that can cause this Kenneth. Let's start with a few questions: How long as..."
perrynbecky1 posted an answer for this 1999 Nissan Altima:
"That was a waste of time. The knock sensor's only function is to sense spark knock or..."