Haier Heating & Cooling - Page 8 - Recent Questions, Troubleshooting & Support

The same controls that are on the hand held remote are also on the unit below the LED screen. However, you may need to manually turn the ON/OF Switch to OFF and unplug the unit for 10 minutes, so that the electronics will revert back to the original factory settings.So, the control panel on the unit will activate for manual use.

I hope this helped you and thanks for choosing FixYa.

Check to see if the compressor is running. If it is not running you may have a bad start relay or capacitor that is causing your unit to not turn on. A lot of AC motors need a kick in the pants to start and those items are like cattle prods if you know what I mean.

What's the question? If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

type,model,make?

Need model number please. If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Need model number If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

It is possible the coil is freezing. Have you noticed any frost behind the filter? If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

So it's likely not fully evaporative. Must be high humidity and auto evaporate can not keep up. It just means your unit is working great. Drain it! If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Empty it, read the manual!! If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Error "FL" is coming It is not going by applying suggesstion in your booklet kindly enlighten

It is quite likely that there is a collection tray or tank for condensation inside the machine. The outlet pipe is quite likely blocked. Disconnect it from the mains (just in case) and gently push a piece of wire or stiff plastic rod (strimmer cord ?) up the pipe.