Dualit Food Mixers - Recent Questions, Troubleshooting & Support

1. Use the plug to rotate and pull out the plate 2. remove the two screws circled in yellow 3. Very carefully unclip the top of the handle, the clips are easy to break 4. remove the spring 5. unclip the black plunger, by squeezing the tabs underneath 6. disconnect the switch board 7. remove the screw circled in yellow 8. the whole assembly can now be removed from the housing

What are you trying to open?

To gain access to the gear housing you will need a small flat bladed screwdriver and a 15mm A/F hexagon bar (Allen key). Insert the screwdriver into the small rectangular slot located at the front end of the base plate. Insert the hexagonal bar into the recess on the base plate. With the screwdriver, gently release the plastic retaining finger by deflecting it towards the rear of the machine at the same time turning the hexagon bar clockwise to release the bayonet locking mechanism. The base plate can then be lifted free of the mixer body. The retaining screw located immediately below the base plate and to the rear of the opening can be removed to enable the motor assembly to be slid rearwards BUT I haven't yet worked out how to disconnect the switch from the motor to enable complete removal. Colin A.

There is 2 screws if you look at the bottom, where the cable is wind. you can seethem through the winding wheel. I had a completly dead machine, by removing these screws i could replace the cable and my machine works again :-)