Audio Players & Recorders - Page 6 - Popular Questions, Answers, Tips & Manuals
Audiolab 8000av What is the solution for error code 5?
The error may deprive you of options. But the "options" for a fix are pretty limited to the following:
Contact IAG: Reach out to IAG, the manufacturer of Audiolab products. They can provide you with a set of codes to re-enable the missing options (such as MPEG2, HDCD, DTS, and Prologic II) if they disappear again.
Corrupted EEPROM: The problem might be related to a corrupted EEPROM (Electrically Erasable Programmable Read-Only Memory). IAG's service technicians should be able to address this issue for you.
Reset: While the manual doesn't explicitly mention a reset sequence for the Audiolab 8000AV, you can try the following steps:
Press "analog + normal + video" buttons simultaneously.
Then press the "display" button to restore factory settings.
This may help regenerate a system code and potentially resolve the issue.
Remember that this is a specific issue related to the Audiolab 8000AV, and contacting IAG for assistance is your best course of action
4/1/2024 12:59:37 AM •
The Audio...
•
14 views • 0 helpful votes
I have a JVC RX-501 reciver and 2 speakers Sony(200W). I start the reciver and After 3-4 seconds it S make a sound like" bun bun " that S all... After 1-2 minute again..
The sound you're hearing could be due to a variety of reasons, such as a loose connection, a malfunctioning component, or a power issue. Here are some steps you can take to troubleshoot the issue:
Check the speaker connections: Ensure that the speaker wires are properly connected to the receiver and the speakers. Make sure that the positive and negative terminals are correctly aligned. You can also try disconnecting and reconnecting the wires to ensure a secure connection.
Check the power source: Ensure that the receiver is plugged into a working power outlet and that the power cord is securely connected to the receiver. You can also try plugging the receiver into a different power outlet to see if that resolves the issue.
Check the volume level: Ensure that the volume level on the receiver is not set too high. High volume levels can cause distortion and other issues.
Reset the receiver: Try resetting the receiver to its default settings. To do this, turn off the receiver and unplug it from the power source. Wait for a few minutes, then plug the receiver back in and turn it on.
If these suggestion don't help, you may have to seek professional repair.
2/2/2024 5:05:55 PM •
JVC Audio...
•
30 views • 0 helpful votes
1997 JVC RC-X270 does not read CDs
A bit of basic knowledge is required first;
Insert CD, the first thing the processor expects is to scheive Focus.
When Focus is acheived, the Spindle Motor will turn.
Either the Laser cannot Focus or there is an issues with the Spindle Motor.
Which is it ... if you know, then you will know which part or board has the issue.
1/29/2024 5:24:21 PM •
JVC Audio...
•
31 views • 1 helpful votes
Not finding what you are looking for?