Questions & Answers for: wiper motor slipping

wiper motor but arms dont move. i can move them by hand. when wiper motor running i hear fuse box clicking it sounds like the wiper transmission has broken/slipped off of the wiper motor. Remove wiper

...wiper motor or the connector for the wiper motor has a problem. Corrosion in the connector(s) (if there is a separate wiper control module) can cause this. Also the slip ring inside the wiper motor ...

...do not go to park position-- Larry Sounds like the slip ring in the wiper motor has a strip missing from it,if so you need a new wiper motor,parts for wiper motors are next to impossible to

...wiper motor, if good, turn the wipers on, tap lightly on the wiper motor and see if it starts working, if it does work after tapping on it, the wiper motor might be failing or the circuit board. The ...

wiper motor that should have a bare spot to stop them in the park position,if the wipers won't "park" then you need a new wiper motor because parts are'nt available to make the repairs to the motor it

...slipped a joint and now the motor will turn but it will not turn the wiper arms. You will have to open up the wiper panel and visually check to see what part has failed in that wiper

Wiper motor arm disengaged or slipping on drive shaft. Wiper arms slipping on splines at pivot point of wiper arm.,,,more likely. Wipers are held to drive splines with a 10mm nut. Make sure wipers are

If the fuses check out, your wiper motor may be bad. The transmission in the wiper motor may be out, causing it to slip. If that all checks out, it may be your actual wiper switch that needs replaced

...is turned off. Operate normally when turned on. Wipers don't flip off side when turned on so attaching bolt has not loosened. The gears in the wiper motor are slipping, Get a new wiper

...wiper motor. Use a voltmeter to check for power and ground on the Pink and dark green wires. This setup has two relays: hi speed and low speed. If you're not getting power and ground with IGN switch ...