...you stop. They can cost from $20.00 to $150.00 per rotor, depending on the vehicle. They can be turned at the auto repair shop for about $10.00 per rotor. There is 1 rotor per wheel. Turning them ...
...turn rotors, the only reason to turn a rotor is if it is running out, what this means is that it is moving back and forth and not in a straight line. What a brake tec is suppose to do is place a dial ...
...will cause the new rotors to warp also I've always had the rotors measured to see if they can be turned. Usually about $20 tops on each. Sometimes cheaper. Some rotors can be pretty pricey. Turned ...
...are okay, bring it by somewhere like firestone and they'll turn the rotors on the vehicle... Your front brake rotors are warped have them turned on a brake rotor lathe or replace them with new
...down the highway and just shuts off when i took the distributor cap off the rotor button was not turning as i turned the truck over is that a bad distributor I'm not familiar with your car, but
...will be scored too bad to resurface. If you feel a vibration when braking, your rotors should be turned. If your brake pads wore out and cut grooves in the rotor, the rotor should be turned. If
...rotors, which are difficult to turn. Is that true? I agree with what you were told about turning the rotors. With the lower cost of replacement rotors and the metal in the original rotors, does make ...
Question about New Syma S107 Mini Indoor Gyro
turn your top rotor, do any of the gears move? Try holding the gear while turning the rotor also, if the rotor is spin able while holding the gear then your rotor shaft is damaged and the entire rotor
Question about New Syma S107 Mini Indoor Gyro
...turn the top rotor. So I'm thinking that maybe the rotors plastic sleeve was glued to the shaft and that came loose. But I'm a little hesitant to put glue in there until I'm sure! I note that the ...
...turn" the rotors yourself, as this will almost certainly result in rotors which are still uneven, or, more dangerously, ground too thin to be safely used. DO NOT attempt to grind rotors yourself, or ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions