Questions & Answers for: tighten shock

...Install or connect the following: Retaining nut and grommet on the stem. Tighten the nut to 106 inch lbs. (12 Nm). Shock absorber-to-lower control arm bolts and tighten to 22 ft. lbs. (30 Nm) ...

...shock absorber mounting bracket (18183). Insert bolt and tighten nut to 60-81 Nm (45-60 lb-ft). Attach the lower end of the front shock absorber to the U-bolt plate by installing the nut and bolt. ...

...Tighten three top mount-to-shock tower nuts to 30-40Nm (23-29 lb-ft). 15.Lower vehicle and tighten hub nut to 230-275 Nm (170-202 lb-ft) 16.Depress brake pedal several times prior to moving vehicle. ...

...nuts. Tighten the mounting nuts to 15 ft. lbs. (20 Nm). Shock cover Trunk trim Shock-to-control arm bolts and tighten the bolts to 18 ft. lbs. (24 Nm) ELC air tube to the shock. Tire and wheel ...

shock absorber. Install the nut to the tennon end. Do not tighten the nut. Remove the safety stands. Lower the vehicle. Hold the tennon end with a wrench while torquing the nut.Tighten Tighten the nut

...tighten the shock absorber installation nut so that the dimensions shown in the illustration ( A and B) are at the standard values. These standard values are: A - 0.04-0.08 in. (1-2mm), B - 0.06-0.10 ...

...Tighten the shock absorber-to-body bolts to 29 ft. lbs. (39 Nm). Tighten the shock absorber-to-axle carrier nuts to 166 ft. lbs. (226 Nm) on 1988-91 vehicles and 188 ft. lbs. (255 Nm) on 1992-96 ...

shock tighten down just till rubber squeezes 1/8 in past washer. if tou over tighten on upper style #2 shock it will split new rubber washers.#1 style can be tighten till stops. hope this info is what

...shock into place and tighten the lower nut. Pop the top of the shock into place and bolt the upper bolt through the holes the same way you removed it. Tighten the nus and bolt in the same point they ...

...tighten the shock bolt with the Snap-on adapter and since the adapter is not going to be at 90 degrees to the torque wrench it will lengthen the torque wrench and therefore the torque value must be ...