Questions & Answers for: thrust washer

...AND THE IT DOES'T SPIN THE WATER OUT. Check the belt, the pump, and the thrust washer.The thrust washer wears down and won't release the tub. All these symptoms are easily repaired with minimal

Thrust washers i am working on a friends 1994 isuzu pickup 2.6L 4cyl engine. he wants me to put a new rear main oil seal in it and new thrust washers in around the crank shaft, i found one half of the

...on a 22r engine and also what the backlash should be set at. i would like to find an exploded view of the bottom end of the engine the thrust washer is in the number 3 or middle main bearing ...

washer making rattle noise during wash and spin cycle one site said thrust bearing, can it be anything else? could be rattle noise maybe grinding (not sure) Washer does operate, wash, and ...

...thrust washer kit still did ot fix the problem. After checking the high speed curcuit it was found that the contacts in the fimer were burnt and lacked follow. Adjusting the spring slightly and ...

...thrust washer on the front axle differential of a 2003 Silverado 4x4? a thrust washer is there to take up lateral movement in the differential, if the washer is not their, their will be to much side ...

thrust washer and needle thrust bearing from wheel bearing adjusting nut. Remove the adjusting nut lock key, then the nut.Remove the rotor and replace the bearings, races and seal as necessary. Torque

...to have a bad thrust bearing would the washer still agitate with a bad thrust bearing. Thank u for your time. you may have a bad lid switch.. if so the washer will fill with water then do

need to put new crankshaft thrust washers in a 2004 Hyundai Elantra how do I do this? Need to know where to put the thrust washers in if you go to www.kiatechinfo.com and make a free account you can ...

...thrust clearance is greater than maximum, replace the thrust washers as a set. Thrust washer thickness: 2.440 - 2.490 mm 10.0961 - 0.0980 in.) See here p101