...system, remove splash shield under right front fender for easy access to water pump bolts, loosen clamps and disconnect hoses from pump, remove drive belt, remove water pump pulley bolts, remove ...
...pulley bolts. Remove accessory drive belts. 1. Remove automatic tensioner. Disconnect coolant hoses from water pump. Remove retaining bolts, water pump and gasket. Installation To install, reverse ...
...thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These ...
...pulley system. will eventually stop working causing overheating problems The clutch fan will usually make more noise immediately after startup and then quiet down. If this is bothersome and you think ...
...thread rope through double pulley system I purchased a Prohoist kayak hoist, but the instructions don't include how to thread the rope through the pulleys so both ends of the kayak are lifted ...
...system into a suitable container. Remove the drive belt guard. Loosen the water pump pulley bolts before removing the drive belt. This should help keep the pulley from turning as the bolts are ...
of the belt. Just thread it in over, under, over under until the last pulley is the tensioner pulley. Then use the 1/2" breaker bar to get the pulley to allow the belt to slide onto it and you're done
...pulley and around the lip of the tool. Thread the tool in until the shells fit on both the pulley and the tool lip. Install the circular metal band to keep the shells in place. Hold the threaded head ...
system. Remove fan assembly. Loosen the water pump pulley bolts. Remove or disconnect the following: Drive belt Water pump drive pulley bolts Water pump drive pulley Radiator inlet hose clamp and hose
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions