...car. Can somebody tell me what's wrong? one of two things ignition switch or starter relay dissconnect the small wire on your starter put a test light on it if its turning over all the time this wire ...
car ignition switch on, find one that's live, then turn the ignition switch off it should go off. then just cut the wire and connect it together. make sure you have a good ground lead connected to the
...car, inability to start the music system, and others. Here are some pointers if you need to replace your ignition switch. Step 1 - Remove the Steering Column Disconnect the battery cable from the ...
...car not starting The neutral safety switch,and the ignition switch can cause this problem,get a test light and start testing these areas,but start at the ignition wire on the starter to see if the ...
...car starts in any gear. don't know if this an ignition switch problem or a netraul safety switch problem. How can I test the neutral safety switch, and or ignition switch ? Thanks, John It is the ...
test light: Turn the ignition key off and disconnect the wire connector at the module. Disconnect the S terminal of the starter solenoid to prevent the engine from cranking when the ignition is in the
...test light or volt meter and when the car is running, ALL the fuses should be "hot", or register voltage or light up the test light...except for the parking light fuse unless you have the lights on ...
Question about 2006 ION
...Ignition OFF, test for less than 1.0 ohm of resistance between the ground circuit terminal D and ground. ?X If greater than the specified range, test the ground circuit for an open/high resistance. ...
Question about 2008 Chevrolet Uplander LS
...test the ignition circuit for a short to ground or an open/high resistance. If the circuit tests normal, refer to Power Mode Mismatch. Ignition OFF, connect the harness connector at the multifunction ...
Question about 2008 Chevrolet Uplander LS
test lamp to battery negative. Probe ignition switch terminal B. Lamp should light, else fuse or wiring from battery to switch fault. Turn and hold switch in START position. Ignition switch S terminal
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions