Questions & Answers for: Samsung tensioner

problem in monitor 793s (no high tension,power led is belinking,hearing a sound like contact relay (on then off) the led power blinking and there is a sound of contac relay on then off and no high ...

...belt-config.JPG I just fixed mine with the same problem. The belt just popped off the drive nut and tensioner. Tools needed: flathead screw driver and flashlight. Use a screwdriver to 'pop' off the ...

My vcr plays slowly When I try to play a vhs video tape in my tv vcr combo, it plays very slowly with grainy picture for 5 seconds before stoppping all together. This seems to happen when the tape is ...

...is routed. It isn't broken, but it isn't taut as well. It sounds like you have a bad or broken belt tensioner. It is located in the bottom of the unit close to the motor . It is a spring loaded pully ...

...I think they are pretty much the same. The belt frayed and the spring popped off of the belt tensioner. I ordered a new belt and replaced it, but cannot figure out where the spring mounts to

Is there a diagram of how to run the belt on the tensioner, have new belt around drum already. Don't know what it is suppose to look like. Thanks Dave Ball at ([email protected]) Man Im not

belt does not track properly on tensioner, it slips to the outside of the tensioner and binds on the outer lip of the tensioner check tensioner workings with belt off for any wear on tensioner parts ...

...not run. Belt is good. check for power at the outlet and the terminal block then see if the belt tensioner switch has gone bad? located at bottom of motor under the ...

...drums is turning make a squeaking sound Most common for 1990 to current Samsung dryers is the belt tensioner pully squeaking. if you do the following when you first hear the squeak you may save ...

...Lights come on (Drying, Cooling, and End). No codes appear present. Disassembled and found belt tensioner pully locked up. Belt wore through plastic pully allowing the tensioner lever to move far ...