Questions & Answers for: silverado crank sensor

...Silverado, crank sensor installed. can't start truck. After installing a new crank sensor, a Tech 2 will need to be hooked up in order to complete what is called a relearn procedure on the new crank ...

...silverado with a 4.8 8cylinder engine Crank sensor; right (pass.) side of block above the starter. You may have to remove the starter to remove the crank sensor. Knock sensor: There may be 2, a front ...

...silverado 2500 6.0) it reads code 300, i have changed my plugs,wires,mass air flow sensor,crank sensor, oxygen sensor,battery, when i tow my 26ft travel trailer it doesnt come on unless im going down ...

...run when i 2000 silverado 5.3 p0108 code wont run when i try to crank it it runs for half a second and stops fuel pump is good 55psi maf sensor is good po108 is map sensor try replaceing map ...

...crank position sensor on a 2002 silverado Go to Autozone, they can pull up a spec sheet for you for free and give you the instructions on how to replace it. The crankshaft sensor is located in front ...

...Silverado will crank,but not start.changed the fuel filter,but no help. how do i check to see if the crankshaft sensor has gone bad? and,in cubic inches..what does a 4.8L V8 come out to? Easiest way ...

silverado just rebuit transmission, new starter, and checked all fuses. it cranks but will not fire (start) more I crank the more I smell gas. What could it be? why it will not start? try checking the

...silverado 5.7 vortec. I've been struggling with misfire on wet days. The cap and wires were replaced twice to no avail. The engine light has been on for a while : latest code is crank/cam sensor. I ...

7 20 amp fuse. Kept at shop for 3 days. Started ok. Took home. Wouldn't start next morning check the crank sensor that seems to cause intermittent starting stupidness. had that problem on my silverado

...crank sensor is unpluged will engine start i just found the plug and it was not pluged in and my truck turns over but wont start No! If the crank sensor fails the engine will not start. The ignition ...