...they check OK, the Ref volt is there 5 volt, in scanner the angle is registering but no voltage at all on any opening of the throttle please advise replace tps switch and adjust it to factory
...is quad driver which a part of the Electronic Control Module (ECM) The ecm itself may need to be
...buick regal 2003 wont excelerate it starts just fine but no matter how much gas i give it the darn thing crawls I cant get it above 20 miles an hour. Could it be the TPS? It may be the throttle ...
after replacing tps devoleped a miss in motor no sensor codes showing new plugs and wires checked all fuel injectors for ohms show ok Did you get the tps lever under the throttle pin,so it will move ...
Buick Regal that stalls... Changed the fuel pump, fuel filter, replaced upper plunim gasket (found blowed gasket) , replaced egr gasket x2. Still won't run...starts and dies. Will not throttle up. Has
...replace a tps for the small miss at high speed, although it may have seemed plausible at the time. I only replace the tps when it shows degradation on the scanner. Does your computer detect the miss ...
...Buick Regal, it hesitates and even stalls out. I had the oil and filters changed as well as the fuel filter. It is still hesitant and feels like it wants to dye. When I changed the fuel filter it had ...
...TPS, idle air control ,MAF sensor , PCV , and the cars computer. To no avail it has new spark plugs and plug wires... I have taken it to a Buick dealer ship and was told that it's process of ...
1992 buick regal trouble code 22 at stop light car stalls TPS out of adjustment. test with ohmmeter should rise and fall smoothly while turning. any opens in middle of rotation replace tps
Question about 1993 Regal
buick regal custom has the error codes 21 and 15 as they are the same circuit How do I fix it??? I replaced the ECM, the TPS, and the CTS. Any Ideas???? I have no idle at all and it runs very rough...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions