Questions & Answers for: replace crankshaft sensor 1999 dodge

...1999 Dodge Ram 1500 2WD won't shift gears properly unless I let off the gas pedal...the speedometer is not working also, could this be a speed sensor or related to the transmission? Sounds like the ...

...the engine continues to run with no power. What can I do? the 1st thing you do is have the sytem tested for trouble codes, this will most likely show a bad crankshaft or camshaft position

i need to locate the crank shaft cencor on my 1999 dodge ram 1500 The crankshaft position sensor is located on the right rear of the engine block, (where the transmission bolts to the engine).

cant find crankshaft position sensor on my dodge ram 1500 v6 van right back of the engine near bellhousing under exhouse manifold

...replace the crank sensor and or cam sensor. the crank sensor was replaced a month ago. it wont stay running. but he doesnt know where theyare. how can he find them?? On the 4.7L, the cam position ...

...dodge ram 1500 i have change iac tps map sensors still idling high rpm is about 1400 exhaust getting red hot sucking air at back of throtlle body code po505 i have changed iac tps map sensors and ...

...1999 Dodge Ram 1500 5.9 4WD and the overdrive will not work. The gears shift fine from first to third. I have replaced the speed sensor on the rear differential and replaced the TCC solenoid on the ...

...throttle sensor,what else can it be Crankshaft sensor or. Ignition coils or spark plugs Could be an electrical issue. When it stalls, do the dash lights stay on or go off? could be an alternator ...

I have a 1999 Dodge Ram 1500 where is the crankshaft position sensor located at on the drivers side or on the passenger sideit is a 5.9 liter 2 wheel drive automatic Here is a picture of it.

...sensor and Crankshaft position sensor Replaced the two sensors due to a DTC pointing to the Crankshaft Postion Sensor. Now truck is hard to start and is putting out the 4 new DTC codes. Do I need to ...