engine you have. The first is 1-4-2-5-3-6. The second is 1-4-2-3-5-6. The in-line six cylinder engines use: 1-5-3-6-2-4. You should look at the intake manifold to see which firing order your car uses.
...remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut ...
remove the intake manifold. If you are mechanically inclined, it's not that hard. Looks complicated because of all the wires and hoses. Just take your time, keep track of everything you do, take notes
intake Engine had a missfire. Pulled valve cover found cylinder 6 intake rocker had half inch lash. Removed head, changed de ac lifter. Changed head gasket, intake gasket. Bared engine over to inspect
Question about 2008 Edge
Remove intake bolts, they are located in between the intake ports. Check for any brackets that might be holding the intake on the rear part. Then the Intake should come out pretty easily. You can just
...INTAKE GEAR MARK EXHAUST GEAR MARK RH Bank (Bank 1) Small Mark Single Line LH Bank (Bank 2) Large Mark Double Line HINT When the engine is correctly timed, the timing marks will NOT perfectly align. ...
...engine hose and position aside. 7. Remove the 3 bolts from the coolant pump assembly. 8. Reposition the coolant pump-to-thermostat housing hose clamp and remove the coolant pump and hose as an ...
...Engine & Drivetrain May 7, 2010 - 2 posts - ?2 authors ISO torque specs for the intake & plenum for a 98 Windstar...3.8 with the ... Our community is here to help you with any questions you ...
......
...Remove upper engine cover. 6. Remove protective shield from under engine. 7. Detach and remove air intake tube from throttle body and air filter housing. 8. Disconnect electrical and vacuum ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions