Questions & Answers for: range switch hyundai elantra

...switch "A" circuit range/performance from the diagnostic at the Hyundai dealership -yesterday, when accelerating from a stop light, it would not go past 2nd gear. I had to pull over, come to a ...

...malfunction, the key is the check eng light have the codes checked and get back to me with the trouble code that set the check eng light. I suspect the trans range selector switch may be

...Range Switch? Car won't start. Recent wet weather. Relays, fuses, starter motor, starter solenoid, park and neutral have all been tested. Engine does not crank when the key is turned to start engine. ...

...codes P0705 because check engine light was on P0705 - Range switch signal incorrect P1529 - MIL on request (from TCM). P0705 tells you there's a problem with the transaxel range switch. Replace

...hyundai elantra with a 2.0 L engine trouble code, po707 comes up and I have lost my code book can you tell me what it is it says trans range sensor circuit low input thank you [email protected] It ...

...range switch could be shorted. Other than that, it's pretty much guaranteed that the problem is within the transmission. The fact that the car moves in reverse means that the range switch ...

Range Switch (if Automatic Trans), Starter Relay, Starter Clutch Pedal Position Switch (if manual Trans) Fuse & Starter Solenoid). Based on your description, the problem is in the Control Circuit.

how do i replace the reverse light switch on a 1997 hyundai elantra it mounted an the transmision case wheare the shith linkage call range sensor

...switch/solenoid, but have to remove console. having trouble doing any suggestions as to what may be bad; how to remove console? tks fernando Bring it to a service center, and consider trading the car ...

...lamp switch is just behind the battery box beside the slave cylinder mount. if this is an automatic transaxle it is built into the trans range switch that shift cable moves on top of