Questions & Answers for: pool heater won 39 ignite

...Pool Heater won't start. When turning it on I used to here a a couple of noises, like a tick, tick then it would ignite. I don't here those sounds anymore. Gas is on water flow seems normal. ...

...heater (teledyne-laars). It won't ignite. The electronic ignition clicks normal briefly then clicks quieter until it no longer clicks. Any body have any idea? I have a model ESC 250k propane heater ...

heater won't start. comes on for about 2 seconds and blows hot air , then clicks off. message says check ignition. It ignites, but won't stay lit heater won't start. comes on for about

H400IDL gas pool heater won't start shows SF error code ran when closed pool won't when opening serial # 30312726 model H400IDL 400,000 BTU check pressure switch

...pool heater pressure sensor? My heater won't ignite and gives a low pressure indicator. check pressure switch to see if voltage both sides if not see if copper tube is plugged make sure filters ...

...heater is not running and will not run. How do I clear the reading? I'm assuming it won't start because it thinks the water is too hot.? minimax nt 250dv temp reading is 105 but heater is not ...

...the click that let's you know the gas was released, I smell the gas, yet the heater won't catch and fire. Any thoughts? hot surface igniter may not be hot enough to ignite the ...

jandy lite 2 pilot won't start check fuses that go to ignitor if ok ohm out ignitor when unplugged should be about 78 ohms if shorted or open replace if ok check safety circuit

pool heater will not light I cleaned the burners, igniter, and flame sensor. The igniter does glow. The fan comes on. Gas flows. The burners will not light. After 3 tries, I get 1F code. Why won't

Heater won't ignite and leaking water bad heat exchange probably ruined ignitor