...down you will have to add a 1/2 inch pipe ,about 5 inches is long enough.Use the pipe to clamp your hose to with adjustable clamps not Spring clamps.The pipe serves as a union here. Please rate this
...pipe clamp screw and the hose pipe clamp. Clamp off the heater hoses. Fig. 1: Heater hose and pipe routing-3.4L engine Fig. 2: Heater hose and pipe routing-3.8L engine Fig. 3: Heater hose and pipe ...
Question about 1998 Gs 400
...clamp to the bracket on the water bypass pipe. Install the water bypass pipe with the bolt. Torque: 18 N.m (185 kgf.cm, 13 ft.lbf) 3.INSTALL REAR WATER BYPASS JOINT 4.INSTALL INTAKE MANIFOLD ASSEMBLY ...
...clamp on each hose; (3)slip the piece of pipe into both hose ends to connect the two hoses together; (4)install and tighten clamps on each end of hoses over pipe. (You might want to put a little ...
...pipe clamp the pipe on both sides of the hole, cut out the bad bit and force 1 peace of copper brake/fuel pipe about 2inch long into either end of the rubber pipe so they are vertually touching clamp ...
...weld and the shield rattles on the pipe easy repair use a hose clamp open the hose clamp up put the clamp around the pipe reconnect the hose clamp slide it over the heat shield and tighten the clamp ...
...pipe clamp hasnt been put back on ,so the o ring will still be their on the pipe ,now what i often do as a temporary fisx is couple of plastic ties to hold it back into position and a more permanant ...
...pipe. Assuming your clamp bolts will loosen. Loosen bolts on the doughnuts clamp. remove the clamp. Then pry the tail pipe away from the manifold and remove the old dougnut gasket. Spray it down with ...
clamp bolt to 60-96 in-lbs (6.8-10.8 Nm), tighten the two bolts with lockwashers, tighten the four TORCA clamps to 45-60 ft-lbs (61- 81 Nm) in the following order, crossover pipe to left side muffler,
Question about Tape Self-fusing Silicone Tape 2 Wide X 36 Roll Industrial Size Clear
...You are better off using a repair clamp. Measure the outside diameter of the pipe. Go to a local plumbing supply house and ask for a repair clamp that will fit the diameter of the
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions
