Questions & Answers for: paykel pump resistance ohms

...pump port...Wires should be disconnected to allow enough rotation......Reverse procedure to replace...Pump resistance should be no less than 33 ohms if 230v, or 7 ohms if 120v......Good ...

...pump ~motor resistance is 33 ohms. If the pump is open circuit, has the thermal onnectlon cut out tripped? This should reset within 15 minutes after tripping once the pump has cooled down. If the ...

The electronic display is totally dead. No LED lights will illuminate Replace motor control board. IF phase 5 ;check pump has a resistance of 34 ohm cold..

...resistance of the pump should be 33 ohms. You need to always check resistances of the sub-components when you do have a dead control. Water valves: 64 ohms Diverter valve: between .7 K ohms and 2.5 K ...

...Paykel washing machine (approx 9 yrs old) and after it filled with water and drained the water, it beeped unbalance so i added something else to balance and started it over. After that It wouldn't ...

...pump.If the resistance is ok then clean the drain pump and drain hose to which the pump is connected.Clean it with normal tap water.Then refit it and check.In most of the cases cleaning the pump and ...

...Paykel IW810AU has stopped mid wash full of water and just beeps constantly and flashes message I need Service Fault 105. Have turned it on and off at the wall with no change. Please help. Hi, the ...

...pump motor and measured the resistance between red, blue and white to be 17 ohms. Any ideas, befor I change the motor controller? Fault code 49 is water valves - usually, the stop working when the ...

...Paykel GWL10 fault code 104 LED light 2,3 and 5 are on beeping your display or pump could at fault here. measure resistance at pump, if resistance in less than 33 ohms, replace your pump. Check ...

...Paykel Aquasmart WL80T65C 5 years old with fault 245, then 49. After getting fault 245 I opened the pump and cleaned out a mass of heavy fluff from a pillow that had broken, plus a coin and rubbish. ...