Questions & Answers for: mustang low idle

...mustang 5spd. The trans, driveshaft and rear end vibrate in all gears between 1000-1600 rpms when I am either driving slowly at an idle speed or when I start to slow down at low speeds in gear. ...

low idle. 78,000mi recent very low idle almost stalling. Hwy miles 2006 GT. plugs never changed. TPS not changed or cleaned nor throttle body. Did replace a battery early in the year. Most often, ...

...low when idle I have a 1999 3.8L Mustang and just finished rebuild. The oil pressure drops to L when idling. When driving, it is normal. I have done everything the manual suggested and it still reads ...

...mustang heater blows cold when idling heater blows cold when idling make sure you have the right thermostat installed Also make sure the radiator is full enough. In earlier models I have had - if it ...

...94 5.0 mustang is having problems starting and when it starts runs like the idle is low till its ran for a while could it be just the fuel filter or pump maybe or something else FAST IDLE

mustang idling rough at low rpm with no power until higher rpm Have done full tune up including plugs, wires, coil pack, air and fuel filter and have even replaced the camshaft synchronizer. Have done

mustang gt? Hold the idle at 2000 RPM for 2 minutes then drop it to 1500 for 2 minutes and then 1000 for 2 minutes, then let it return to idle for 5 minutes. Full relearn requires some driving as

mustang low dle po171 Low idle,dies po171,red hot cats mustang forum solution. http://www.moddedmustangs.com/forums/v6-mustangs/39429-trouble-code-po171.html I had the same problem. Scroll down in ...

...mustang 3.8 never dies but seem's close.every 6 to 10 seconds no difference noticed while driving down the road. changed AIC valve for a c low idle surge at stop lights? probably cause by the a/c ...

...mustang shows 50 psi at 75 degrees, when at normal temp pressure drops to 15,20 at idle. At 2,000 rpm shows 40 psi. This sounds low to me, is this normal? That sounds normal. There would be ...