Questions & Answers for: lowbeam headlights

...lowbeam headlights on, daytime running lights go out. Turn high beams on and they work fine. Turn lights off, daytime running lights come on again. Why are the lowbeam headlights not working? perhaps ...

...headlights. Check the headlight relay and the combination switch. If there is even a flicker of lowbeams when you activate the dimmer switch, it is probably bad. There is also a rare possibility both ...

the passenger lowbeam on my 1999 gmc envoy blew last week, but when I turn on the lowbeams, that light flickers. does this mean there's a short to that headlight and not that I have to spend $1300.00

My left headlight highbeam light works and the lowbeam don't why My left headlight highbeam light works and the lowbeam does not why? the filament on the low beam burnt out. but the high beam didn't. ...

...headlights don't work, the highbeam/lowbeam lever on the steering colum switches highbeams on and off. Fuses and bulbs have been replaced. check the lowbeam headlight relay located in the fuse panel ...

...lowbeam headlights...bulbs have been replaced but still no lowbeam The 2003 Trailblazer has separate fuses for each headlight. Check the fusebox under the hood near the battery. A complete diagram ...

lowbeam headlights Do not have lowbeam headlights on a 2005 Hyundai XG350 yes,the low beam lights turn on when night time comes around,the high beams come on after you push the stick that controls the

headlights the lowbeam lights will not come on. I switched the highbeam and lowbeam wires to see if it was the wires or the lights. the lowbeam lights came on when i put the high beam wires on them. I

one headlight on my 04 f250 lowbeam only won't work even with new bulb drivers side headlight lowbeam is out even with new bulb Try a new Relay. Sometimes Ford uses the same part in other sockets.

headlights, but my highbeam on the right side is higher, but when lowbeam is on they are even. what is that cause? just put 2 after market headlights in. the 2 screw's 10mm when i tighten down it seem