...scanner the ready light blinks green then settles on Red. Sofware says to remove paper in scanner. There is no paper in the scanner and everything appears to be normal. I have another scanner just ...
Question about Magellan 1000i Barcode Scanner - P/N MG10-2010-101-106 Barcode Scanner
scanner the light goes out. It doesn't matter where we have the scanner. We have 2 registers and the other scanner doesn't do this. If you are using magellan 1000i with no button, then it must be your
Question about ScanPrisa 640P Flatbed Scanner
...scanner light comes on then goes off the green power light flashes. and it seems the scanner id trying to work but cannot complete the scan i have and Acer 640P please help. I want the driver ...
...not moving while you give a scan command? If this is true this is something unusual. May be you have some hardware problem. S. Mohan Chennai scanner not scanining scaner light on but document not ...
scanner beam does not move. The scanner neon lights up. If the motor (light) does not move after a scan command, it could be a hardware problem. Try uninstalling and reinstalling of the scanner driver
Question about ScanPartner 15C Flatbed Scanner
...properly. It must be the scanner itself. The scanner light is on also if that helps trouble shooting. Open the document feeder and check to see if there are pieces of paper stuck in the
Question about PowerLook 2100XL Flatbed Scanner
...OR SCAN. wore my Umax Scaner 2100 xlmy problem. power and ready light is blinking If you are using Windows XP, You must power up the scanner before switching your computer on. This is essential
...the scanner is connected to the pc. if the scanner only ahs the red light and no other lights on the scanner come on then you will need a replacement scanner - contact the tech support to arrange ...
Question about ScanMaker 5600 Flatbed Scanner
Light is Scanner will not connect to computer. Light is yellow not green. have tried twoo different USB cords. Should light turn green before the computer recognizes scanner? I found that I need a new
...light on the scanner is red until three beeps are heard (low/medium/high), a low beep after the light goes out, and then rapidly med/high beeps as the light on the scanner starts blinking in green. ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions