Questions & Answers for: where is the latch switch

the latch on kenmore micro #721-62622200 is broken at bottom I ordered a new latch and spring (just in case) from Sears, it arrived today but I can't figure out how to take the door apart. I can't ...

...Could be a bent latch or latch assembly that?s not actuating the latch switch correctly or that the latch switch itself is bad. Check the door switch, too. plse do not forget to accept the

...switch - if the washer will run, the switch is making contact, but the latch is defective. If it won't run, either the latch switch is bad, or the issue may be the control panel. Best regards,

...switch and the door latch. To replace the door switch you have to remove the front panel. Remove the two screws holding the door switch assembly in place and drop the door switch assembly down into ...

...latch switch, then from latch switch to control. If no damage to wires and all connectors okay, proceed to step C. 3. Repeat steps A and B for door switch. 3. Measure door switch (door open = switch ...

...switch is on the latch, you will need to remove the door panel and then remove the latch, with the latch out you will see the switch is on the latch held in by a screw, note there are two switches on ...

...latch switch do not function, you may need to replace them F5-E2 means latch during clean error; the door and latch switch need checking and possible replacement. 1. If door latched: Disconnect power ...

...latch. Is the switch in the latch defective or is there an electrical problem in a door module. A new latch is $400 and a used latch is $250. sounds like the door sense switch has failed inside the ...

...latch switch or the door open/closed switch mechanism isn't responding correctly. If the error occurred when starting a self-clean cycle, look at the door latch and switch before the door closed ...

...latch position switch is supplied with a constant ground source. When the switch is active, the RDM will detect a switched ground signal on the folding top outer latch position switch latched signal ...