Questions & Answers for: jet hyosung carbs

...hyosung 250 comet with less than 1000km on the clock it is a 2005 model but has been sitting around for a couple of years. I have changed the fuel and plugs, blown out the fuel lines and carbs with ...

...eventually take off with power, but only for a few seconds then it boggs out again? any help? The jets in the carb need cleaned. Please rate this a fixya maybe sycn the carbs too ,clean out your ...

...Hyosung GV250 starts and idles fine, but when I give it the gas, it bogs down and dies. Also, I can only run it at the most at half choke. Fully open choke will cause it to die even after running a ...

...carbs how to rejet carburetor Remove the carb. Remove the throttle slide. Remove the float bowl. The main jet is right in the center and has a number stamped on it (110, 200, etc) The pilot is the ...

...hyosung GT125R has a tough time idling when the weather is cold and/or wet. I have to keep it alive by twisting the throttle every so often while stopped. However, the bike runs and idles great in ...

hyosung gt 250 comet??? Hi, you could remove the drain screw from the bottom of the float chamber, this is the lowest Point on the carburettor, however if u are having running problems, the best thing

...hyosung gv250 that won't idle. We have carbs apart and my buddy took the carbs apart without measuring the turns on the jets. What's the proper turn for the pilot screw. And is he pilot screw ...

...up a hill. Once you get beyond 5500 rpm, it is fine, but it takes it a little whi I had the carb jets cleaned professionally about a year ago because the bike was sitting in a garage for two years ...

hyosung 250 Aquila been parked in storage. Starts briefly, then shuts off. Will not register throttle use. Fuel in tank, new battery and terminals fully charged, sounds/seems like a fuel delivery. How

...Hyosung GT125R. It's been stood since Covid and it won't start. I have had the carbs off and cleaned the jets and put it all back on but there still nothing. The engine is trying to start. Am I ...